JVC CA-MXGT91R manual Common Operations, Turning On or Off the Power Setting the Clock

Page 12

Common Operations

Turning On or Off the Power

Setting the Clock

To turn on the unit, press

STANDBY/ON so that the STANDBY lamp goes off.

To turn off the unit (on standby), press

STANDBY/ON again so that the STANDBY lamp lights up.

The clock appears on the display (if Ecology Mode is not activated).

STANDBY/ON

STANDBY

STANDBY/ON

STANDBY

Before operating the unit any further, first set the clock built in this unit. You can set the clock whether the system is on or off.

On the unit ONLY:

1 Press CLOCK/TIMER.

The hour digits start flashing on the display.

2 Turn 4/ ¢to adjust the hour, then press SET/DISPLAY.

A little power is always consumed even while the unit is on standby.

To switch off the power supply completely, unplug the AC

power cord from the AC outlet.

When you unplug the AC power cord or if a power failure occurs

The clock is reset to “0:00” right away, while the tuner preset stations (see page 12) will be erased in a few days.

Saving the Power Consumption While on Standby — Ecology Mode

You can save the power consumption only while the unit is turned off (on standby).

To activate the Ecology Mode, press ECO. “ECO” appears and the display illumination (including the display demonstration) disappears from the display.

Each time you press the button, “ECO” and “NORMAL” appear alternately on the display.

To deactivate the Ecology Mode, press ECO again. “NORMAL” appears and the display illumination appears on the display.

About Ecology Mode

You can also activate and deactivate Ecology Mode while the unit is on, but it takes effect only when the unit is on standby.

While Ecology Mode is activated, the display demonstration is canceled temporarily.

The minute digits start flashing on the display.

• If you want to correct the hour after pressing

SET/DISPLAY, press

CANCEL/DEMO.

The hour digits start flashing again.

3 Turn 4/ ¢to adjust the minute, then press SET/DISPLAY.

To check the clock time

Press and hold SET/DISPLAY while playing any source.

Each time you press and hold the button, the source indication and the clock time alternate on the display.

To adjust the clock again

If you have adjusted the clock before, you need to press CLOCK/TIMER repeatedly until the clock setting mode is selected.

Each time you press the button, the clock/timer setting modes change as follows:

DAILY ON TIME REC

Canceled Clock ON TIME setting

(The hour digits start flashing.)

When you unplug the AC power cord or if a power failure occurs

The clock loses the setting and is reset to “0:00.” You need to set the clock again.

– 9 –

Image 12
Contents CA-MXGT91R CA-MXG71R Class Laser Product Above ALL Precautions IntroductionAbout This Manual Contents Location of the Buttons and Controls Front PanelFront Panel Become familiar with the buttons and controls on your unitDisplay Window See pages in the parentheses for detailsRemote Control Remote ControlSubwoofer Level + / buttons 10 o Volume + / buttons CD 3´8button 9, 16Supplied Accessories Connecting AntennasGetting Started FM antennaConnecting Speakers Close the speaker terminalsAM MW/LW antenna To connect an outdoor AM MW/LW antennaConnecting Other Equipment Canceling the Display DemonstrationOn the unit only To connect an analog componentTurning On or Off the Power Setting the Clock Saving the Power Consumption While on Standby Ecology ModeCommon Operations Adjusting the Volume To turn down the volume level temporarilySelecting the Sources Reinforcing the Bass SoundCreating Your Own Sound Mode Manual Mode On the unit only Select one of the preset sound modesTo use your own sound mode Tuning in a Station Presetting StationsTuning in a Preset Station On the unit only Tune in the station you want to presetPress Display Mode Receiving FM Stations with RDSSearching for Programs by PTY Codes PTY Search Changing the RDS InformationSwitching to a Program Type of Your Choice Temporarily Press PTY/EON once againTo activate the EON function More about the EON functionPlaying Back CDs CD/CD-R/CD-RW Loading CDsPress the same 0 you have pressed in step Repeat steps 1 to 3 to place other CDsPlaying Back the Entire Discs Continuous Play Basic CD OperationsProgram Play Playing at Random Random Play Repeating Tracks or CDs Repeat PlayProhibiting Disc Ejection Tray Lock To exit from Random play mode, press Random againPlaying Back Tapes Playing Back a TapeLocating the Beginning of a Song Music Scan To clean the heads, capstans, and pinch rollers RecordingRecording a Tape on Deck B To protect your recordingTo record on both sides Reverse Mode Dubbing TapesCD Direct Recording Press DubbingAuto Edit Recording Using the Timers Using Daily TimerPress CLOCK/TIMER again How Daily Timer actually worksWhen selecting Tuner FM or Tuner AM When selecting CDTurn 4/ ¢to set the volume level Press SET/DISPLAY to complete the Daily Timer settingUsing Recording Timer Select the preset stationHow Recording Timer actually works Unit enters preset station selecting modeUsing Sleep Timer Timer PriorityOn the remote control only Press Sleep Wait for about 5 seconds after specifying the time lengthAdditional Information Description of the PTY codesR. M Troubleshooting SymptomMaintenance Cleaning the unitTo clean the disc Handling discsSpecifications Memo Memo Anmärking angående inspelning av RDS FM- stationer Registrering af en FM station med RDSHuomautus nauhoittaessasi RDS-FM-aseman lähetystä 0201MWMMDWJEM SP-MXGT91R Connection Anschluss Aansluitingen Collegamento Tilslutning