JVC CA-MXGT91R manual Troubleshooting, Symptom

Page 31

Troubleshooting

If you are having a problem with your unit, check this list for a possible solution before calling for service.

If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person, such as your dealer, for service.

Symptom

Unable to cancel the display demonstration.

No sound is heard.

Hard to listen to broadcasts because of noise.

The disc sound is discontinuous. The disc tray does not open or close.

The disc does not play.

The cassette holders cannot be opened.

Impossible to record.

Operations are disabled.

Unable to operate the unit from the remote control.

Cause

Other buttons will pressed to cancel the display demonstration.

Connections are incorrect or loose.

•Antennas are disconnected.

•The AM (MW/LW) loop antenna is too close to the unit.

•The FM antenna is not properly extended and positioned.

The disc is scratched or dirty.

•The AC power cord is not plugged in.

•Trays are locked.

The disc is placed upside down.

Power supply from the AC power cord has been cut off while the tape was running.

Small tabs on the back of the cassette are removed.

The built-in microprocessor may malfunction due to external electrical interference.

•The path between the remote control and the remote sensor on the unit is blocked.

•The batteries are exhausted.

Action

Press CANCEL/DEMO on the unit. (See page 8.)

Check all connections and make corrections. (See pages 6 to 8.)

•Reconnect the antennas correctly and securely.

•Change the position and direction of the AM (MW/LW) loop antenna.

•Extend the FM antenna at the best position.

Clean or replace the disc. (See page 29.)

•Plug the AC power cord.

•Unlock the trays. (See page 18.)

Place the disc with the label side up.

Turn on the unit.

Cover the holes with adhesive tape.

Unplug the AC power cord and then plug it back in.

•Remove the obstruction.

•Replace the batteries.

– 28 –

Image 31

Contents CA-MXGT91R CA-MXG71R Class Laser Product Above ALL Introduction PrecautionsAbout This Manual Contents Become familiar with the buttons and controls on your unit Location of the Buttons and ControlsFront Panel Front PanelSee pages in the parentheses for details Display WindowCD 3´8button 9, 16 Remote ControlRemote Control Subwoofer Level + / buttons 10 o Volume + / buttonsFM antenna Supplied AccessoriesConnecting Antennas Getting StartedTo connect an outdoor AM MW/LW antenna Connecting SpeakersClose the speaker terminals AM MW/LW antennaTo connect an analog component Connecting Other EquipmentCanceling the Display Demonstration On the unit onlySaving the Power Consumption While on Standby Ecology Mode Turning On or Off the Power Setting the ClockCommon Operations Reinforcing the Bass Sound Adjusting the VolumeTo turn down the volume level temporarily Selecting the SourcesOn the unit only Select one of the preset sound modes Creating Your Own Sound Mode Manual ModeTo use your own sound mode On the unit only Tune in the station you want to preset Tuning in a StationPresetting Stations Tuning in a Preset StationChanging the RDS Information Press Display ModeReceiving FM Stations with RDS Searching for Programs by PTY Codes PTY SearchMore about the EON function Switching to a Program Type of Your Choice TemporarilyPress PTY/EON once again To activate the EON functionRepeat steps 1 to 3 to place other CDs Playing Back CDs CD/CD-R/CD-RWLoading CDs Press the same 0 you have pressed in stepBasic CD Operations Playing Back the Entire Discs Continuous PlayProgram Play To exit from Random play mode, press Random again Playing at Random Random PlayRepeating Tracks or CDs Repeat Play Prohibiting Disc Ejection Tray LockPlaying Back a Tape Playing Back TapesLocating the Beginning of a Song Music Scan To protect your recording To clean the heads, capstans, and pinch rollersRecording Recording a Tape on Deck BPress Dubbing To record on both sides Reverse ModeDubbing Tapes CD Direct RecordingAuto Edit Recording How Daily Timer actually works Using the TimersUsing Daily Timer Press CLOCK/TIMER againPress SET/DISPLAY to complete the Daily Timer setting When selecting Tuner FM or Tuner AMWhen selecting CD Turn 4/ ¢to set the volume levelUnit enters preset station selecting mode Using Recording TimerSelect the preset station How Recording Timer actually worksWait for about 5 seconds after specifying the time length Using Sleep TimerTimer Priority On the remote control only Press SleepDescription of the PTY codes Additional InformationR. M Symptom TroubleshootingHandling discs MaintenanceCleaning the unit To clean the discSpecifications Memo Memo Registrering af en FM station med RDS Anmärking angående inspelning av RDS FM- stationerHuomautus nauhoittaessasi RDS-FM-aseman lähetystä 0201MWMMDWJEM SP-MXGT91R Connection Anschluss Aansluitingen Collegamento Tilslutning