JVC CA-MXGT91R manual Class Laser Product

Page 2

Warnings, Cautions and Others

IMPORTANT for the U.K.

DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appro- priate safety approved extension lead or consult your dealer.

BE SURE to replace the fuse only with an identical approved type, as originally fitted.

If nonetheless the mains plug is cut off ensure to remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the mains supply.

If this product is not supplied fitted with a mains plug then follow the instructions given below:

IMPORTANT:

DO NOT make any connection to the terminal which is marked with the letter E or by the safety earth symbol or coloured green or green-and-yellow.

The wires in the mains lead on this product are coloured in accordance with the following code:

Blue : Neutral

Brown : Live

As these colours may not correspond with the coloured markings identifying the terminals in your plug proceed as follows:

The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.

The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.

IF IN DOUBT - CONSULT A COMPETENT ELECTRICIAN.

Caution –– STANDBY/ON button!

Disconnect the mains plug to shut the power off completely. The

STANDBY/ON button in any position does not disconnect the mains line. The power can be remote controlled.

CAUTION

To reduce the risk of electrical shocks, fire, etc.:

1.Do not remove screws, covers or cabinet.

2.Do not expose this appliance to rain or moisture.

IMPORTANT FOR LASER PRODUCTS

REPRODUCTION OF LABELS

1CLASSIFICATION LABEL, PLACED ON REAR ENCLOSURE

CLASS 1

LASER PRODUCT

2WARNING LABEL, PLACED INSIDE THE UNIT

 

DANGER:

Invisible

laser

 

VARNING: Osynlig laser-

 

ADVARSEL: Usynlig

laser-

 

VARO: Avattaessa ja

suo-

 

 

radiation

when open

and

 

strålning när denna del är

 

stråling ved åbning,

når

 

jalukitus ohitettaessa

olet

 

 

interlock failed or defeated.

 

öppnad och

spärren

är

 

sikkerhedsafbrydere

er

ude

 

alttiina

näkymättömälle

 

 

AVOID DIRECT EXPOSURE

 

urkopplad.

Betrakta

ej

 

af funktion. Undgå udsæt-

 

lasersäteilylle. Älä katso

 

 

TO BEAM.

 

(e)

 

strålen.

 

(s)

 

telse for stråling

 

(d)

 

säteeseen.

 

(f)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1.CLASS 1 LASER PRODUCT

2.DANGER: Invisible laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam.

3.CAUTION: Do not open the top cover. There are no user serviceable parts inside the Unit; leave all servicing to qualified service personnel.

CAUTION

Do not block the ventilation openings or holes.

(If the ventilation openings or holes are blocked by a newspaper or cloth, etc., the heat may not be able to get out.)

Do not place any naked flame sources, such as lighted candles, on the apparatus.

When discarding batteries, environmental problems must be considered and local rules or laws governing the disposal of these batteries must be followed strictly.

Do not use this apparatus in a bathroom or places with water. Also do not place any containers filled with water or liquids (such as cosmetics or medicines, flower vases, potted plants, cups, etc.) on top of this apparatus.

Caution: Proper Ventilation

To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows:

1 Front:

No obstructions and open spacing.

2 Sides/ Top/ Back:

No obstructions should be placed in the areas shown by the dimensions below.

3 Bottom:

Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm or more.

Front view

 

 

 

 

 

15 cm

 

 

 

 

 

 

 

 

 

 

 

1 cm

 

(5 15/16 in.)

15 cm

 

1 cm

(7/16 in.)

 

(7/16 in.)

(5 15/16 in.)

 

 

 

 

 

 

 

 

 

 

 

 

 

CA-MXGT91R

CA-MXG71R

Side view

 

 

 

 

 

 

 

15 cm

15 cm

15 cm

(5 15/16 in.)

 

(5 15/16 in.)

(5 15/16 in.)

 

 

 

 

 

 

CA-MXGT91R

CA-MXG71R

10 cm

(3 15/16 in.)

G-1

Image 2
Contents CA-MXGT91R CA-MXG71R Class Laser Product Above ALL About This Manual PrecautionsIntroduction Contents Front Panel Location of the Buttons and ControlsFront Panel Become familiar with the buttons and controls on your unitDisplay Window See pages in the parentheses for detailsSubwoofer Level + / buttons 10 o Volume + / buttons Remote ControlRemote Control CD 3´8button 9, 16Getting Started Supplied AccessoriesConnecting Antennas FM antennaAM MW/LW antenna Connecting SpeakersClose the speaker terminals To connect an outdoor AM MW/LW antennaOn the unit only Connecting Other EquipmentCanceling the Display Demonstration To connect an analog componentCommon Operations Turning On or Off the Power Setting the ClockSaving the Power Consumption While on Standby Ecology Mode Selecting the Sources Adjusting the VolumeTo turn down the volume level temporarily Reinforcing the Bass SoundTo use your own sound mode Creating Your Own Sound Mode Manual ModeOn the unit only Select one of the preset sound modes Tuning in a Preset Station Tuning in a StationPresetting Stations On the unit only Tune in the station you want to presetSearching for Programs by PTY Codes PTY Search Press Display ModeReceiving FM Stations with RDS Changing the RDS InformationTo activate the EON function Switching to a Program Type of Your Choice TemporarilyPress PTY/EON once again More about the EON functionPress the same 0 you have pressed in step Playing Back CDs CD/CD-R/CD-RWLoading CDs Repeat steps 1 to 3 to place other CDsPlaying Back the Entire Discs Continuous Play Basic CD OperationsProgram Play Prohibiting Disc Ejection Tray Lock Playing at Random Random PlayRepeating Tracks or CDs Repeat Play To exit from Random play mode, press Random againLocating the Beginning of a Song Music Scan Playing Back TapesPlaying Back a Tape Recording a Tape on Deck B To clean the heads, capstans, and pinch rollersRecording To protect your recordingCD Direct Recording To record on both sides Reverse ModeDubbing Tapes Press DubbingAuto Edit Recording Press CLOCK/TIMER again Using the TimersUsing Daily Timer How Daily Timer actually worksTurn 4/ ¢to set the volume level When selecting Tuner FM or Tuner AMWhen selecting CD Press SET/DISPLAY to complete the Daily Timer settingHow Recording Timer actually works Using Recording TimerSelect the preset station Unit enters preset station selecting modeOn the remote control only Press Sleep Using Sleep TimerTimer Priority Wait for about 5 seconds after specifying the time lengthR. M Additional InformationDescription of the PTY codes Troubleshooting SymptomTo clean the disc MaintenanceCleaning the unit Handling discsSpecifications Memo Memo Huomautus nauhoittaessasi RDS-FM-aseman lähetystä Anmärking angående inspelning av RDS FM- stationerRegistrering af en FM station med RDS 0201MWMMDWJEM SP-MXGT91R Connection Anschluss Aansluitingen Collegamento Tilslutning