JVC CA-MXGT91R manual Using Recording Timer, Select the preset station, If necessary

Page 28

Using Recording Timer

With Recording Timer, you can make a tape of a radio broadcast automatically. You can set the timer whether the system is on or off.

How Recording Timer actually works

The unit automatically turns on, tunes into the specified station, sets the volume level to “VOL MIN,” and starts

recording when the on-time comes (the indicator flashes just before the on-time, and continues flashing while the timer is operating). Then, when the off-time comes (“OFF” appears just before the off-time), the unit automatically turns off (on standby).

The timer setting remains in memory until you change it.

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

To correct a mis-entry while setting the timer, press

CANCEL/DEMO.

On the unit ONLY:

1 Put a recordable cassette into deck B.

2 Press CLOCK/TIMER repeatedly until “REC” appears on the display.

The REC (Recording Timer) indicator also starts flashing on the display.

Each time you press the button, the timer setting modes change as follows:

DAILY ON TIME REC

Canceled Clock ON TIME setting

(See page 9.)

3 Press CLOCK/TIMER again.

“ON TIME” appears for 2 seconds, then the unit enters on-time setting mode.

4 Set the on-time you want the unit to turn on at.

1) Turn 4/ ¢ to set the hour, then press SET/DISPLAY.

2)Turn 4/ ¢to set the minute, then press SET/DISPLAY.

“OFF TIME” appears for 2 seconds, then the unit enters off-

time setting mode.

5 Set the off-time you want the unit to turn off (on standby) at.

1)Turn 4/ ¢ to set the hour, then press

SET/DISPLAY.

2)Turn 4/ ¢ to set the minute, then press

SET/DISPLAY.

The unit enters preset station selecting mode.

6 Select the preset station.

1)Turn 4/ ¢to select the band (“TUNER FM” or “TUNER AM”), then press SET/DISPLAY.

2)Turn 4/ ¢ to select a preset channel number, then press SET/DISPLAY.

The REC (Recording Timer) indicator stops flashing and remains lit. The settings you have done are shown on the display in sequence.

7 Press STANDBY/ON

to

STANDBY/ON

turn off the unit (on standby)

STANDBY

if necessary.

 

 

If you want to listen to another source while recording Press REC START/STOP or 7 to stop recording. Without stopping it, you cannot change the source.

Even if you unplug the AC power cord or if a power failure occurs

Once you set the timer, the timer setting may remain stored in memory in a few days. In this case, check whether the timer setting still remains or not.

– 25 –

Image 28
Contents CA-MXGT91R CA-MXG71R Class Laser Product Above ALL Introduction PrecautionsAbout This Manual Contents Location of the Buttons and Controls Front PanelFront Panel Become familiar with the buttons and controls on your unitDisplay Window See pages in the parentheses for detailsRemote Control Remote ControlSubwoofer Level + / buttons 10 o Volume + / buttons CD 3´8button 9, 16Supplied Accessories Connecting AntennasGetting Started FM antennaConnecting Speakers Close the speaker terminalsAM MW/LW antenna To connect an outdoor AM MW/LW antennaConnecting Other Equipment Canceling the Display DemonstrationOn the unit only To connect an analog componentSaving the Power Consumption While on Standby Ecology Mode Turning On or Off the Power Setting the ClockCommon Operations Adjusting the Volume To turn down the volume level temporarilySelecting the Sources Reinforcing the Bass SoundOn the unit only Select one of the preset sound modes Creating Your Own Sound Mode Manual ModeTo use your own sound mode Tuning in a Station Presetting StationsTuning in a Preset Station On the unit only Tune in the station you want to presetPress Display Mode Receiving FM Stations with RDSSearching for Programs by PTY Codes PTY Search Changing the RDS InformationSwitching to a Program Type of Your Choice Temporarily Press PTY/EON once againTo activate the EON function More about the EON functionPlaying Back CDs CD/CD-R/CD-RW Loading CDsPress the same 0 you have pressed in step Repeat steps 1 to 3 to place other CDsPlaying Back the Entire Discs Continuous Play Basic CD OperationsProgram Play Playing at Random Random Play Repeating Tracks or CDs Repeat PlayProhibiting Disc Ejection Tray Lock To exit from Random play mode, press Random againPlaying Back a Tape Playing Back TapesLocating the Beginning of a Song Music Scan To clean the heads, capstans, and pinch rollers RecordingRecording a Tape on Deck B To protect your recordingTo record on both sides Reverse Mode Dubbing TapesCD Direct Recording Press DubbingAuto Edit Recording Using the Timers Using Daily TimerPress CLOCK/TIMER again How Daily Timer actually worksWhen selecting Tuner FM or Tuner AM When selecting CDTurn 4/ ¢to set the volume level Press SET/DISPLAY to complete the Daily Timer settingUsing Recording Timer Select the preset stationHow Recording Timer actually works Unit enters preset station selecting modeUsing Sleep Timer Timer PriorityOn the remote control only Press Sleep Wait for about 5 seconds after specifying the time lengthDescription of the PTY codes Additional InformationR. M Troubleshooting SymptomMaintenance Cleaning the unitTo clean the disc Handling discsSpecifications Memo Memo Registrering af en FM station med RDS Anmärking angående inspelning av RDS FM- stationerHuomautus nauhoittaessasi RDS-FM-aseman lähetystä 0201MWMMDWJEM SP-MXGT91R Connection Anschluss Aansluitingen Collegamento Tilslutning