JVC CA-MXGT91R manual Recording a Tape on Deck B, To protect your recording

Page 23

Recording

Continued

IMPORTANT:

It should be noted that it may be unlawful to re-record pre-recorded tapes, records, or discs without the consent of the owner of copyright in the sound or video recording, broadcast or cable programme and in any literary, dramatic, musical, or artistic embodied therein.

The recording level is automatically set correctly, so it is not affected by the VOLUME, the SUBWOOFER LEVEL, and the SOUND MODE controls. Thus, during recording you can adjust the sound you are actually listening to without affecting the recording level.

If recordings you have made have excessive noise or static, the unit may be too close to a TV. Increase the distance between the TV and the unit.

You can use type I tape for recording.

To protect your recording

Cassettes have two small

tabs on the back to protect

from unexpected erasure or re-recording.

To protect your recording, remove these tabs.

To re-record on a protected tape, cover the holes with adhesive tape.

To keep the best recording and playback sound quality

If the heads, capstans, and pinch rollers of the cassette decks become dirty, the following will occur:

Impaired sound quality

Discontinuous sound

Fading

Incomplete erasure

Difficulty in recording

To clean the heads, capstans, and pinch rollers

Use a cotton swab moistened with alcohol.

Pinch rollers

Capstans

Heads

To demagnetize the heads

Turn off the unit, and use a head demagnetizer (available at electronics and audio shops).

Recording a Tape on Deck B

1 Press EJECT 0for the deck B.

2 Put a recordable cassette into deck B.

3 Close the cassette holder gently.

4 Check the tape direction of deck B.

If the tape direction is not correct, press TAPE 2 3 twice then 7to change the tape direction.

5 Start playing the source — FM, AM (MW/ LW), CD player, deck A, or auxiliary equipment connected to AUX jacks.

When the source is CD, you can also use CD Direct Recording (see page 21) and Auto Edit Recording (see page 22).

When the source is deck A, you can also use the dubbing method. (See “Dubbing Tapes” on page 21.)

6 Start recording. On the unit:

Press REC START/STOP. On the remote control:

Press and hold REC START/STOP for more than 1 second.

The (recording) indicator lights up on the display and recording starts.

If no cassette is inserted, “NO TAPE” appears on the display. If a protected tape is inserted, “NO REC” appears on the display.

To stop recording immediately, press 7.

To remove the cassette, press EJECT 0for deck B.

– 20 –

Image 23
Contents CA-MXGT91R CA-MXG71R Class Laser Product Above ALL About This Manual PrecautionsIntroduction Contents Become familiar with the buttons and controls on your unit Location of the Buttons and ControlsFront Panel Front PanelSee pages in the parentheses for details Display WindowCD 3´8button 9, 16 Remote ControlRemote Control Subwoofer Level + / buttons 10 o Volume + / buttonsFM antenna Supplied AccessoriesConnecting Antennas Getting StartedTo connect an outdoor AM MW/LW antenna Connecting SpeakersClose the speaker terminals AM MW/LW antennaTo connect an analog component Connecting Other EquipmentCanceling the Display Demonstration On the unit onlyCommon Operations Turning On or Off the Power Setting the ClockSaving the Power Consumption While on Standby Ecology Mode Reinforcing the Bass Sound Adjusting the VolumeTo turn down the volume level temporarily Selecting the SourcesTo use your own sound mode Creating Your Own Sound Mode Manual ModeOn the unit only Select one of the preset sound modes On the unit only Tune in the station you want to preset Tuning in a StationPresetting Stations Tuning in a Preset StationChanging the RDS Information Press Display ModeReceiving FM Stations with RDS Searching for Programs by PTY Codes PTY SearchMore about the EON function Switching to a Program Type of Your Choice TemporarilyPress PTY/EON once again To activate the EON functionRepeat steps 1 to 3 to place other CDs Playing Back CDs CD/CD-R/CD-RWLoading CDs Press the same 0 you have pressed in stepBasic CD Operations Playing Back the Entire Discs Continuous PlayProgram Play To exit from Random play mode, press Random again Playing at Random Random PlayRepeating Tracks or CDs Repeat Play Prohibiting Disc Ejection Tray LockLocating the Beginning of a Song Music Scan Playing Back TapesPlaying Back a Tape To protect your recording To clean the heads, capstans, and pinch rollersRecording Recording a Tape on Deck BPress Dubbing To record on both sides Reverse ModeDubbing Tapes CD Direct RecordingAuto Edit Recording How Daily Timer actually works Using the TimersUsing Daily Timer Press CLOCK/TIMER againPress SET/DISPLAY to complete the Daily Timer setting When selecting Tuner FM or Tuner AMWhen selecting CD Turn 4/ ¢to set the volume levelUnit enters preset station selecting mode Using Recording TimerSelect the preset station How Recording Timer actually worksWait for about 5 seconds after specifying the time length Using Sleep TimerTimer Priority On the remote control only Press SleepR. M Additional InformationDescription of the PTY codes Symptom TroubleshootingHandling discs MaintenanceCleaning the unit To clean the discSpecifications Memo Memo Huomautus nauhoittaessasi RDS-FM-aseman lähetystä Anmärking angående inspelning av RDS FM- stationerRegistrering af en FM station med RDS 0201MWMMDWJEM SP-MXGT91R Connection Anschluss Aansluitingen Collegamento Tilslutning