JVC CA-MXGT91R manual Using the Timers, Using Daily Timer, Press CLOCK/TIMER again

Page 26

Using the Timers

There are three timers available — Daily Timer, Recording Timer, and Sleep Timer.

Before using the timers, you need to set the clock built in the unit. (See page 9.)

Using Daily Timer

With Daily Timer, you can wake to your favorite music or radio program. You can set the timer whether the unit is on or off.

How Daily Timer actually works

The unit automatically turns on, set the volume level to the preset level, and starts playing the specified source when the

on-time comes (the indicator flashes just before the on- time, and continues flashing while the timer is operating). Then, when the off-time comes (“OFF” flashes just before the off-time), the unit automatically turns off (on standby).

The Daily timer works everyday automatically. If you do not want to use the Daily timer, turn off the Daily timer. (See “To turn on or off Daily Timer after its setting is done” on page 24.) The timer setting remains in memory until you change it.

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

To correct a mis-entry while setting the timer, press

CANCEL/DEMO.

On the unit ONLY:

1 Press CLOCK/TIMER repeatedly until “DAILY” appears on the display.

indicator lights up and DAILY (Daily Timer) indicator also starts flashing on the display.

Each time you press the button, the timer setting modes change as follows:

DAILY ON TIME REC

Canceled Clock ON TIME setting

(See page 9.)

2 Press CLOCK/TIMER again.

“ON TIME” appears for 2 seconds, then the unit enters on-time setting mode.

Before you start...

When using a CD as the source to play —

Make sure there is a CD on the selected disc number tray.

When using a tape as the source to play —

Make sure that a tape is in the deck whose deck indicator (A or B) is lit on the display.

Make sure that the tape direction is correct.

When using the external component as the source to play —

Set the timer equipped on the external component at the same time.

3 Set the on-time you want the unit to turn on at.

1) Turn 4/ ¢ to set the hour, then press SET/DISPLAY.

2)Turn 4/ ¢to set the minute, then press SET/DISPLAY.

“OFF TIME” appears for 2

seconds on the display, then the unit enters off-time setting mode.

4 Set the off-time you want the unit to turn off (on standby) at.

1)Turn 4/ ¢ to set the hour, then press

SET/DISPLAY.

2)Turn 4/ ¢ to set the minute, then press

SET/DISPLAY.

The unit enters source selecting mode.

– 23 –

Image 26
Contents CA-MXGT91R CA-MXG71R Class Laser Product Above ALL About This Manual PrecautionsIntroduction Contents Front Panel Location of the Buttons and ControlsFront Panel Become familiar with the buttons and controls on your unitDisplay Window See pages in the parentheses for detailsSubwoofer Level + / buttons 10 o Volume + / buttons Remote ControlRemote Control CD 3´8button 9, 16Getting Started Supplied AccessoriesConnecting Antennas FM antennaAM MW/LW antenna Connecting SpeakersClose the speaker terminals To connect an outdoor AM MW/LW antennaOn the unit only Connecting Other EquipmentCanceling the Display Demonstration To connect an analog componentCommon Operations Turning On or Off the Power Setting the ClockSaving the Power Consumption While on Standby Ecology Mode Selecting the Sources Adjusting the VolumeTo turn down the volume level temporarily Reinforcing the Bass SoundTo use your own sound mode Creating Your Own Sound Mode Manual ModeOn the unit only Select one of the preset sound modes Tuning in a Preset Station Tuning in a StationPresetting Stations On the unit only Tune in the station you want to presetSearching for Programs by PTY Codes PTY Search Press Display ModeReceiving FM Stations with RDS Changing the RDS InformationTo activate the EON function Switching to a Program Type of Your Choice TemporarilyPress PTY/EON once again More about the EON functionPress the same 0 you have pressed in step Playing Back CDs CD/CD-R/CD-RWLoading CDs Repeat steps 1 to 3 to place other CDsPlaying Back the Entire Discs Continuous Play Basic CD OperationsProgram Play Prohibiting Disc Ejection Tray Lock Playing at Random Random PlayRepeating Tracks or CDs Repeat Play To exit from Random play mode, press Random againLocating the Beginning of a Song Music Scan Playing Back TapesPlaying Back a Tape Recording a Tape on Deck B To clean the heads, capstans, and pinch rollersRecording To protect your recordingCD Direct Recording To record on both sides Reverse ModeDubbing Tapes Press DubbingAuto Edit Recording Press CLOCK/TIMER again Using the TimersUsing Daily Timer How Daily Timer actually worksTurn 4/ ¢to set the volume level When selecting Tuner FM or Tuner AMWhen selecting CD Press SET/DISPLAY to complete the Daily Timer settingHow Recording Timer actually works Using Recording TimerSelect the preset station Unit enters preset station selecting modeOn the remote control only Press Sleep Using Sleep TimerTimer Priority Wait for about 5 seconds after specifying the time lengthR. M Additional InformationDescription of the PTY codes Troubleshooting SymptomTo clean the disc MaintenanceCleaning the unit Handling discsSpecifications Memo Memo Huomautus nauhoittaessasi RDS-FM-aseman lähetystä Anmärking angående inspelning av RDS FM- stationerRegistrering af en FM station med RDS 0201MWMMDWJEM SP-MXGT91R Connection Anschluss Aansluitingen Collegamento Tilslutning