Precor TRM 800 warranty Radio Frequency Interference RFI, Federal Communications Commission, Part

Page 10

8

Assembling and Maintaining TRM 800-Series Treadmills

Radio Frequency Interference (RFI)

The RFID module conforms to the following national standards defining acceptable limits for radio frequency interference (RFI).

Federal Communications Commission, Part 15

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a commercial installation. The equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the owner’s manual instructions, can cause harmful interference to radio communications.

Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

WARNING Per FCC rules, changes or modifications not expressly approved by the manufacturer could

void the user’s authority to operate the equipment.

Industry Canada

This device complies with RSS-210:2007 of the Spectrum Management & Telecommunications Radio Standards Specification. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This Class A digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe A est conforme à la norme

NMB-003 du Canada.

ATTENTION: Haute Tension

Débranchez avant de réparer

Image 10
Contents Assembling and Maintaining TRM 800-Series Treadmills Page Page Trademark Note Intellectual Property NoticeImportant Safety Instructions Safety PrecautionsAssembling and Maintaining TRM 800-Series Treadmills Safety Code Educating Users Hazardous Materials and Proper DisposalProduct Recycling and Disposal Regulatory Notices for the Rfid ModuleFederal Communications Commission, Part Radio Frequency Interference RFIIndustry Canada European Applications Safety Approvals for Cardiovascular EquipmentRegulatory Notices for Cardiovascular Exercise Equipment Cardiovascular Type EquipmentUser’s authority to operate the equipment Treadmill Grounding Instructions Electrical Recommendations 240 V TreadmillsObtaining Service Obtaining Updated Documentation North American 120-volt, 20-amp power receptacleTable of Contents Commercial Cardiovascular Equipment Limited Warranty To prepare the treadmill for assembly Assembling the TreadmillInstallation Requirements Required ToolsHardware Kit not to scale FastenersUnpacking the Cables To unpack the cablesRemoval and replacement of the rear fairing cover To begin assembly of the frame Assembling the FrameUpright support attachment, right side To thread cables through the frame PointUpright support attachment, left side Handrail and console assembly attachment To complete assembly of the treadmill base Completing AssemblyTo secure the fasteners Attaching the Power Cord Clips To attach the power cord clipsChecking Treadmill Alignment and Adjusting the Running Belt Power cord placement under front of treadmillLeveling the Unit To level the treadmillPlugging In the Power Cord Breaking in the EquipmentAssembling and Maintaining TRM 800-Series Treadmills Installing the Console Threading the Cable Assembly P80To thread the cable assembly Removing the access cover from the P80 consoleConnecting Cables P80 Connecting the Television Cable To connect the television cableConnecting the Ethernet and Base Unit Data Cables Connecting the television cableConnecting the Heart Rate Sensor Cable Connecting the Power CableCompleting the Console Installation P80 To complete the installationThreading the Cable Assembly P30 and P20 Connecting Cables P30 Connecting Cables P20 Completing the Console Installation P30 and P20 Reassembling the Treadmill Fairing To reassemble the fairingVerifying That the Heart Rate Display Is Operational To verify that the heart rate display is operationalAssembling and Maintaining TRM 800-Series Treadmills Maintenance Daily CleaningDaily Inspection Weekly Maintenance Monthly MaintenanceAdjusting the Running Belt To adjust the running beltChecking the Alignment of the Running Belt To align the running beltMoving the Equipment Storing the Chest StrapTo put the treadmill into an inclined position for moving Long-Term Storage Assembling and Maintaining TRM 800-Series Treadmills Entering the Safety Code To enter the safety code and start the treadmillUsing the Treadmill Safety Clip Restart switchTurning the Treadmill On and Off Weight LimitLocation Assembling and Maintaining TRM 800-Series Treadmills Limited Warranty Warranty Periods and CoverageConditions and Restrictions Exclusive Remedies Exclusion of Consequential and Incidental Damages Complete this portion and keep for your recordsPage Precor Incorporated