Precor TRM 800 warranty Safety Code

Page 7

Important Safety Instructions

5

When using the treadmill, always attach the safety clip to your clothing before beginning your workout. Failure to use the safety clip may pose a greater risk of injury in the event of a fall.

Also, verify that the running belts on treadmills are clean and running smoothly.

Do not allow runners over 350 pounds (160 kg) or walkers over 500 pounds (225 kg) to use the treadmill.

If you plan to move the equipment, obtain help and use proper lifting techniques. Refer to the "Moving the Equipment" section of the assembly and maintenance guide.

Use the equipment only for its intended purpose as described in this manual. Do not use accessory attachments that are not recommended by Precor. Such attachments may cause injuries.

Do not operate the equipment where aerosol (spray) products are being used or where oxygen is being administered.

Do not use outdoors.

Do not attempt to service the equipment yourself, except to follow the maintenance instructions in this manual.

Never drop or insert objects into any opening. Keep hands away from moving parts.

Do not set anything on the stationary handrails, handlebars, control console, or covers. Place liquids, magazines, and books in the appropriate receptacles.

Do not lean on or pull on the console at any time.

CAUTION: DO NOT remove the cover, or you may risk injury due to electric shock. Read the assembly and maintenance guide before operating. There are no user-serviceable parts inside. Contact Customer Support if the equipment needs servicing. For use with single phase AC supply only.

Safety Code

The club owner or manager has the option to enable the safety code. With the code enabled, a user must enter four number keys in the correct order before using the equipment. If the user does not press the correct keys within two minutes, he or she is denied access to the equipment.

Image 7
Contents Assembling and Maintaining TRM 800-Series Treadmills Page Page Intellectual Property Notice Trademark NoteSafety Precautions Important Safety InstructionsAssembling and Maintaining TRM 800-Series Treadmills Safety Code Hazardous Materials and Proper Disposal Educating UsersRegulatory Notices for the Rfid Module Product Recycling and DisposalFederal Communications Commission, Part Radio Frequency Interference RFIIndustry Canada Cardiovascular Type Equipment Safety Approvals for Cardiovascular EquipmentRegulatory Notices for Cardiovascular Exercise Equipment European ApplicationsUser’s authority to operate the equipment Electrical Recommendations 240 V Treadmills Treadmill Grounding InstructionsNorth American 120-volt, 20-amp power receptacle Obtaining Service Obtaining Updated DocumentationTable of Contents Commercial Cardiovascular Equipment Limited Warranty Assembling the Treadmill To prepare the treadmill for assemblyRequired Tools Installation RequirementsFasteners Hardware Kit not to scaleTo unpack the cables Unpacking the CablesRemoval and replacement of the rear fairing cover Assembling the Frame To begin assembly of the frameUpright support attachment, right side Point To thread cables through the frameUpright support attachment, left side Handrail and console assembly attachment To complete assembly of the treadmill base Completing AssemblyTo secure the fasteners To attach the power cord clips Attaching the Power Cord ClipsPower cord placement under front of treadmill Checking Treadmill Alignment and Adjusting the Running BeltTo level the treadmill Leveling the UnitBreaking in the Equipment Plugging In the Power CordAssembling and Maintaining TRM 800-Series Treadmills Threading the Cable Assembly P80 Installing the ConsoleRemoving the access cover from the P80 console To thread the cable assemblyConnecting Cables P80 To connect the television cable Connecting the Television CableConnecting the television cable Connecting the Ethernet and Base Unit Data CablesConnecting the Power Cable Connecting the Heart Rate Sensor CableTo complete the installation Completing the Console Installation P80Threading the Cable Assembly P30 and P20 Connecting Cables P30 Connecting Cables P20 Completing the Console Installation P30 and P20 To reassemble the fairing Reassembling the Treadmill FairingTo verify that the heart rate display is operational Verifying That the Heart Rate Display Is OperationalAssembling and Maintaining TRM 800-Series Treadmills Daily Cleaning MaintenanceDaily Inspection Monthly Maintenance Weekly MaintenanceTo adjust the running belt Adjusting the Running BeltTo align the running belt Checking the Alignment of the Running BeltMoving the Equipment Storing the Chest StrapTo put the treadmill into an inclined position for moving Long-Term Storage Assembling and Maintaining TRM 800-Series Treadmills To enter the safety code and start the treadmill Entering the Safety CodeRestart switch Using the Treadmill Safety ClipTurning the Treadmill On and Off Weight LimitLocation Assembling and Maintaining TRM 800-Series Treadmills Warranty Periods and Coverage Limited WarrantyConditions and Restrictions Exclusive Remedies Complete this portion and keep for your records Exclusion of Consequential and Incidental DamagesPage Precor Incorporated