Precor TRM 800 warranty Installation Requirements, Required Tools

16 Assembling and Maintaining TRM 800-Series Treadmills

5.Remove the shipping fasteners from the front panel using a ¹₄-inch hex key and a ¹⁄₂–inch box-end wrench.

6.Remove any tape or wire ties securing the console cable to the side of the unit.

Before you begin, verify that you have received the following parts:

Base frame assembly

Left and right upright supports

Center fairing with handrails

Hardware kit

Installation Requirements

The location where the treadmill is installed must provide power connections that supply the appropriate voltage, a 20A dedicated branch circuit, and grounding as specified on the treadmill.

CAUTION: Do not use a non-grounded outlet or transformer. Do not remove or otherwise bypass the plug with an adapter. Electrical damage can occur and void the Precor Limited Warranty if the treadmill is connected to an improper power source.

Required Tools

¹₄-inch hex wrench

⁵₃₂-inch hex wrench (ball end is desirable)

¹₂-inch box-end wrench

Bubble level

#2 Phillips screwdriver

String or fish tape

Wire cutter