Precor TRM 800 warranty Weekly Maintenance, Monthly Maintenance

Page 49

Maintenance

47

Weekly Maintenance

Perform the following maintenance tasks every week:

1.Elevate the tread to maximum incline, then turn off the power switch or circuit breaker and unplug the unit from the wall outlet.

2.Clean the floor under the equipment using a vacuum cleaner or a damp mop.

3.When the floor is completely dry, reconnect the power and return the treadmill to the level position.

4.Inspect the power cord to verify that it is not pinched under the equipment or between any two moving parts.

5.Test all console functions, including heart rate monitoring features.

6.Verify that the unit sits squarely on the floor. All of its feet should be touching the floor and the unit should not rock or wobble when in use. If not, re-level it as described in Leveling the Unit.

Monthly Maintenance

DANGER USE EXTREME CAUTION when the rear cover of any EFX is removed. Serious injury could result if

fingers are pinched between the flywheel spokes, cranks, movable arms, and the drive weldment. Securing the movable arm to the crank with a clamp is recommended. Be aware of other people within your work area who might cause the arm to move.

Perform the following maintenance tasks every month:

1.Clean the frame, cover and arms with water or an approved cleaner.

2.Wipe the exterior of the console with a damp sponge or soft cloth, and dry with a clean towel. Keep water away from electronic components to prevent electrical shock or damage.

3.Clean the touchscreen using a soft, lint-free cloth dampened with a 91% isopropyl alcohol solution (either as sold or diluted with an equal amount of water).

4.Remove the rear cover. Vacuum out any debris, being careful not to bring the vacuum cleaner nozzle too close to any circuit board (unless your vacuum cleaner is protected against static buildup).

Image 49
Contents Assembling and Maintaining TRM 800-Series Treadmills Page Page Intellectual Property Notice Trademark NoteSafety Precautions Important Safety InstructionsAssembling and Maintaining TRM 800-Series Treadmills Safety Code Hazardous Materials and Proper Disposal Educating UsersRegulatory Notices for the Rfid Module Product Recycling and DisposalFederal Communications Commission, Part Radio Frequency Interference RFIIndustry Canada Regulatory Notices for Cardiovascular Exercise Equipment Safety Approvals for Cardiovascular EquipmentEuropean Applications Cardiovascular Type EquipmentUser’s authority to operate the equipment Electrical Recommendations 240 V Treadmills Treadmill Grounding InstructionsNorth American 120-volt, 20-amp power receptacle Obtaining Service Obtaining Updated DocumentationTable of Contents Commercial Cardiovascular Equipment Limited Warranty Assembling the Treadmill To prepare the treadmill for assemblyRequired Tools Installation RequirementsFasteners Hardware Kit not to scaleTo unpack the cables Unpacking the CablesRemoval and replacement of the rear fairing cover Assembling the Frame To begin assembly of the frameUpright support attachment, right side Point To thread cables through the frameUpright support attachment, left side Handrail and console assembly attachment To complete assembly of the treadmill base Completing AssemblyTo secure the fasteners To attach the power cord clips Attaching the Power Cord ClipsPower cord placement under front of treadmill Checking Treadmill Alignment and Adjusting the Running BeltTo level the treadmill Leveling the UnitBreaking in the Equipment Plugging In the Power CordAssembling and Maintaining TRM 800-Series Treadmills Threading the Cable Assembly P80 Installing the ConsoleRemoving the access cover from the P80 console To thread the cable assemblyConnecting Cables P80 To connect the television cable Connecting the Television CableConnecting the television cable Connecting the Ethernet and Base Unit Data CablesConnecting the Power Cable Connecting the Heart Rate Sensor CableTo complete the installation Completing the Console Installation P80Threading the Cable Assembly P30 and P20 Connecting Cables P30 Connecting Cables P20 Completing the Console Installation P30 and P20 To reassemble the fairing Reassembling the Treadmill FairingTo verify that the heart rate display is operational Verifying That the Heart Rate Display Is OperationalAssembling and Maintaining TRM 800-Series Treadmills Daily Cleaning MaintenanceDaily Inspection Monthly Maintenance Weekly MaintenanceTo adjust the running belt Adjusting the Running BeltTo align the running belt Checking the Alignment of the Running BeltMoving the Equipment Storing the Chest StrapTo put the treadmill into an inclined position for moving Long-Term Storage Assembling and Maintaining TRM 800-Series Treadmills To enter the safety code and start the treadmill Entering the Safety CodeRestart switch Using the Treadmill Safety ClipTurning the Treadmill On and Off Weight LimitLocation Assembling and Maintaining TRM 800-Series Treadmills Warranty Periods and Coverage Limited WarrantyConditions and Restrictions Exclusive Remedies Complete this portion and keep for your records Exclusion of Consequential and Incidental DamagesPage Precor Incorporated