Precor M9.2s, M9.1 owner manual Handrails

Page 14

Diagram 9

Install upper

 

handrails

Upper handrail clamp

Trim strip

Electronic console display

Upper handrail

Upper handrail clamp

Cable tie & fastener

Ribbon cable

21.Insert the upper end of a handrail into the upper handrail clamp until the black foam wrap just touches the clamp. See Diagram 9. Set the base of the handrail on the floor. Repeat this step for the other handrail.

Note: Look underneath the upper handrail clamp to be sure that the handrail ends meet in the middle of the clamp.

22.Insert the four upper handrail clamp screws (C) into the upper handrail clamp and finger- tighten. Do not tighten the screws more than finger tight at this point.

Diagram 10

Attach lower

 

handrails

Side rail

 

Handrail

 

Plastic cradle

 

Projecting ledge

 

Screw hole

 

Lower handrail clamp

 

23.To mount the lower portion of the handrails to the treadmill, refer to Diagram 10 while taking the following steps:

Note: Perform these steps on one side of the treadmill before proceeding to the other side.

a.Use the supplied hex key (G) to remove the screws that hold the lower handrail clamp in place.

b.Place the lower portion of the handrail onto the plastic cradle. You may need to gently flex the lower portion of the handrail toward the front of the treadmill to securely seat the end of the tube onto the projecting ledge of the cradle.

c.Re-install the handrail clamp over the tube, align the screw holes, insert and finger- tighten each screw.

d.To secure the handrail inside the clamp, use the hex key (G) provided. Do not overtighten the screw or damage may occur to the clamp.

page 8

Image 14
Contents Precision Electronic Treadmill Important Safety Instructions Personal Safety Precor Smart Weights-Safety GuidelinesInformation Regarding International Use FCC Communications Commission, partDiagram a Grounding InstructionsTable of Contents Optional Equipment Before You BeginUnpacking the M9.1 or M9.2s Treadmill BCD Assembly Instructions Setting Up the M9.1 or M9.2s TreadmillInstallation Requirements Install lift ColumnFlanged nuts a Base plate Motor chassis Cross beam PlugBoard HandrailHandrail clamp Handrail clamp not shownAttach electronic console to Lift column OvertightenAttach trim strip to Handrails Checking the Alignment of the Running Belt See Aligning the Running BeltUsing the Magnetic Safety Key Using the M9.1 or M9.2s TreadmillLocating the on and OFF Switch Understanding the Electronic Console Displays on the Electronic ConsoleKeys on the Electronic Console ScanChanging the Display to U.S. Standard or Metric Selecting the Time or Distance Prompt on the M9.2sWorking Out on Your Treadmill TreadmillQuick Steps to Working Out Retrieving the Previous Workout Program Pausing Your WorkoutChanging Incline on the M9.1 Cooling Down After a WorkoutUsing the Manual Course Mode Changing the Interval Course ProfileUsing the M9.2s Preprogrammed Courses Page Getting the Most Out of Your Workout Erector Spinae Gluteals Hip FlexorsHeart Rate Training Zone How Hard Should I Exercise?How Long Should I Exercise? How Often Should I Exercise?Aligning the Running Belt Cleaning the EquipmentMaintaining Your Treadmill Side platform Running bed Rear roller Adjusting the Tension of the BeltRunning belt Servicing the Treadmill Power Cord MaintenanceObtaining Service M9.1 or M9.2s Long Term StorageElectronic Displays SpecificationsElectronic Specifications