C O M M E R C I A L P R O D U C T S D I V I S I O N
Diagram 10 Attach the frame stabilizers to the upright support brackets.
Bolts (G) and washers (H)
Frame stabilizer
| Upright |
| support |
Upper section | bracket |
|
Lower section
17.Attach the left and right frame stabilizers. Diagram 10. Proceed with one side at a time. When you have installed the first stabilizer, perform the same steps on the opposite stabilizer.
a.Remove four bolts (G) and four washers (H) from the Hardware kit. Place a washer on each bolt and set the fasteners within easy reach of the unit.
b.Grasp one of the frame stabilizers and align it with the upright support bracket.
c.Insert the four bolts (G) with washers (H) through the frame stabilizer and upright support bracket. See Diagram 10.
d.Thread all four bolts and washers until the frame stabilizer is secure. Do not fully tighten the bolts until after the lower section is attached.
e.Perform steps a through d on the opposite side.
Diagram 11 Attach the lower frame stabilizers to the base assembly.
Bolts
f.Carefully, align the mounting holes on the right and left frame stabilizer with the base frame holes. Insert four bolts (G) and washers (H) on both sides. Thread the bolts through the unit. See Diagram 11.You may need to adjust and gently move the stabilizers up and down to get the mounting holes on both sides of the base frame properly aligned.
g.Tighten the bolts so that the unit is stable, but leave room for final adjustments. Do not securely tighten the bolts until the unit has been fully assembled.
page 16