C O M M E R C I A L P R O D U C T S D I V I S I O N
IMPORTANT SAFETY INSTRUCTIONS
Diagram 1 Avoid injury from the roller arm mechanism.
Ramp
Front cover
Handlebar
Lower pivot roller arm (handlebar linkage)
•Never place your hand(s) or feet in the path of the roller arm because injury may occur to you or damage may occur to the equipment. Refer to Diagram 1.
•Never operate the unit if it is damaged, if it is not working properly, if it has been dropped, or dropped in water. Return the unit to a service center for examination and repair.
•Keep the optional battery recharger cord away from heated surfaces.
•Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
•Do not use outdoors.
•Do not attempt to service the EFX yourself other than the assembly and maintenance instructions found in this manual. Refer to Obtaining Service.
HAZARDOUS MATERIALS AND PROPER DISPOSAL
The EFX534 has an internal battery which must be removed before the EFX is scrapped.The battery contains materials which are considered hazardous to the environment. Proper disposal of the battery is required by federal law.
To remove the battery from the EFX, take the following steps:
CAUTION: Unplug the battery recharger and disconnect it from its receptacle at the rear of the EFX.
Tools required: Phillips head screwdriver and hex wrench set.
1.Remove both the right and left rear covers from the EFX.
2.Remove the top rear cover.
3.Unplug the black and red battery wires from the circuit board.
4.Separate the circuit board from the battery by removing four screws.
5.The battery is held in place with a metal bracket. Lift the battery away from the bracket.
6.Dispose of the battery according to the federal Hazardous Waste Regulations.
SAFETY APPROVAL
When identified with the
IMPORTANT SAFETY INSTRUCTIONS
SAVETHESE INSTRUCTIONS
page 3