Precor owner manual Assembling the 904 Total Body Treadmill, Installation Requirements

Page 7

Assembling the 904 Total Body Treadmill

Follow the instructions in this section to assemble the 904 Total Body Treadmill. It is important to read through the entire procedure before assem- bling your treadmill. If you do not assemble and use this treadmill according to the following guidelines, you could void the Precor limited warranty.

Installation Requirements

Follow these installation requirements when installing the treadmill:

•Fill out and mail the limited warranty registration card. The serial number is written on a label underneath the treadmill on the side beam. During the assembly process, write the serial number on the limited warranty card and in this Owner’s Manual (see Obtaining Service). If you want a 904 Technical Service Manual, write to:

ATTN: 904 Technical Service Manual Precor Customer Service Department P.O. Box 3004

Bothell, WA 98041-3004

•Set up the 904 treadmill on a solid, flat surface.We recommend placing the treadmill on a low-pile carpet. Do not install the treadmill on hardwood floors because the wheels might scratch or damage the surface. If the treadmill is placed on a hardwood floor or a deep-pile carpet, place a piece of heavy cardboard, plywood, or other flat surface under the unit to protect the floor or carpet. If the floor is not flat and even, the running belt may not track properly.

•Locate the treadmill at least 2 feet from walls and furniture. Open space to the front, sides, and rear of the machine make for a safer mount and dismount and easier belt adjustment.

page 7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Total Body Treadmill Please review and observe the following safety guidelines Safety InformationKeep hands away from the flywheel and other moving parts Table of Contents Unassembled 904 treadmill Unpacking the 904 Total Body TreadmillTips for unpacking the treadmill Hardware kit Assembling the 904 Total Body Treadmill Installation RequirementsPreparing to install the front lift bar Assembly InstructionsTo assemble the 904 treadmill, take the following steps Installing the Front Lift Bar assembly Knob Removing hardware from the T-knob assemblySliding the rod through the right handrail mount Rest the right handrail on the safety stop Installing the right handrail Knob assemblyOperation Installing the left handrail Securing the T-knob assemblyDiagram That it screws into the rodAdjusting the Elevation Tube Floor, before you let go of the handrails Placing the treadmill on its sideChecking the Alignment of the Running Belt Beginning Your Workout Using the Precor 904 Total Body TreadmillEnding Your Workout Working Out on the 904 Treadmill Total Body TreadmillUsing the Handrails Adjusting the Handrail Resistance Tips for using the handrails followUsing the Micro-Adjustment Knob Forearm Flexors/Extensors General Aerobic Training Information155 175165 160How Often Should I Exercise? How Long Should I Exercise?Maintaining the 904 Total Body Treadmill Cleaning the TreadmillStoring the Treadmill Aligning the Running Belt Adjustment bolt clockwise another 1/2 turn Rear of the treadmill. See DiagramIs not covered by the limited warranty Adjustment boltLubricating the Running Belt Obtaining ServiceN36520-102 Web Version 9/98
Top Page Image Contents