ProForm PFTL97007.0 user manual Troubleshooting, Problem The power turns off during use

Page 26

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual.

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 12). Use only a single-outlet surge suppres- sor that meets all of the specifications described on page 12. Important: The treadmill is not com- patible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is inserted into the console.

c.Check the reset/off circuit breaker located on the treadmill frame near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.

PROBLEM: The power turns off during use

c

Tripped

Reset

SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c.Remove the key from the console. Reinsert the key into the console.

d.If the treadmill still will not run, please see the front cover of this manual.

PROBLEM: The console displays remain lit when you remove the key from the console

SOLUTION: a. The console features a display demo mode, designed to be used if the treadmill is displayed in a store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE INFORMATION MODE on page 23 to turn off the demo mode.

PROBLEM: The displays of the console do not function properly

SOLUTION: a. Remove the key from the console and UNPLUG

a

74

THE POWER CORD. With the help of a second

 

 

 

person, carefully tip the Uprights (74, 78) down.

 

 

There may be two Hood Screws (108) in the bottom

 

 

of the Belly Pan (73). If there are, remove them.

 

 

Note: A Phillips screwdriver with a shaft at least 5

78

73

in. (13 cm) long is required. Then, raise the

Uprights.

 

 

 

 

108

 

 

108

26

Page 25 Page 27
Image 26
Page 25 Page 27
Contents Call TOLL-FREE QUESTIONS?Please do not Contact On the WEBTable of Contents Important Precautions Page Before YOU Begin Assembly Make sure that the power cord is unplugged Do not fully fold the Frame yet Be careful not to pinch the Upright WireGers do not fully tighten the Bolts yet Tighten the Nut the Wheel must turn freelyPower is Turned on Not Connected PROPERLY, the CON Sole MAY be Damaged WhenSee steps 4 and 6. Tighten the 3/8 x 4 1/2 BoltsSmall Screws PRE-LUBRICATED Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord Console Diagram Features of the ConsoleSelect the user mode HOW to Turn on the PowerHOW to Personalize Console Settings Insert the key into the consoleSet the date and time Select a default user settingHOW to Identify Yourself AS User 1 or User Select the manual mode HOW to USE the Manual ModePersonalize console settings if desired Start the walking belt and adjust the speedMeasure your heart rate if desired Press the Start button to start the workout HOW to USE a Classic WorkoutSelect a preset classic workout HOW to USE AN Event Training Workout Select an event training workoutHOW to Create a Custom Workout Select one of the four custom workoutsHOW to USE a Custom Workout HOW to View the Fitness Journal Exit the user mode HOW to Reset the Fitness JournalSelect the user mode. See on Reset the fitness journal Information ModeOptional Chest Pulse Sensor HOW to USE the Stereo Sound SystemHOW to Adjust the Cushioning System HOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USETroubleshooting Problem The power turns off during useProblem The walking belt slows when walked on Page Workout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencyR0108A Key No. Qty DescriptionQty Exploded Drawing A-Model No. PFTL97007.0 R0108A Exploded Drawing B-Model No. PFTL97007.0 R0108A Exploded Drawing C-Model No. PFTL97007.0 Exploded Drawing D-Model No. PFTL97007.0 R0108A Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty
Top Page Image Contents