ProForm PFTL97007.0 Not Connected PROPERLY, the CON Sole MAY be Damaged When, Power is Turned on

7. Set the console assembly face down on a soft	7
surface to avoid scratching the console assem-
		Console
bly. Hold the Right Handrail (95) near the con-
		Wire
sole assembly. Next, insert the console wire into
the large hole in the Right Handrail and out of
the top as shown. If necessary, use needlenose
pliers to help pull the console wire out.	95	1
Attach the Right Handrail (95) and the Left			1
Handrail (not shown) with four #8 x 3/4" Screws
(1) (only one side is shown). Make sure that no
wires are pinched. Start all four Screws be-	Console
fore tightening any of them; do not over-
	Assembly
tighten the Screws.
8. Tighten a 1/4" x 1 1/4" Bolt (5) with a 1/4" Star	8	Wire
Washer (33) into the bracket and Handrail
Crossbar (94) on each side of the console as-		Tie
sembly (only one side is shown).		5
Remove the wire tie from the console wire.		33
	Console
	Assembly
		94
9. Remove the long tie from the Upright Wire (38).	9
Have a second person hold the console assem-
bly near the Right Upright (78) and Left Upright
(not shown). Connect the Upright Wire (38) to	Console
the console wire. See the inset drawing. The
connectors should slide together easily and	Assembly
snap into place. If they do not, turn one connec-
tor and try again. IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE	Console
POWER IS TURNED ON.
	Wire
Set the console assembly on the Right Upright		38	Console
(78) and Left Upright (not shown). Be careful
			Wire
not to pinch the wires.		Long
	78
		Tie
			38
	9