ProForm crosswalk 500 user manual Again. if the Connectors are not CON

5. Attach two Base Pads (82) to the Base (108)	5
with two 1" Tek Screws (83) as shown.
Insert the other Extension Leg (89) into the		82	108
Base (108) as shown. Hold two Extension Leg
Nuts (67) in the bottom of the Extension Leg.			65
Next, insert two Extension Leg Bolts (65) into
			82
the top of the Extension Leg, and firmly tighten
the Extension Leg Bolts into the Extension Leg
Nuts.
With the help of a second person, carefully tip		83
the treadmill so that all four Base Pads (82) are			67
flat on the floor.
			89
6. Have the second person hold the console as-	6
sembly near the Right Upright (107) as shown.
Look under the console assembly and locate
the console wire.			Console
Remove the tie from the Wire Harness (77).			Assembly
Connect the Wire Harness to the Console Wire
(66). See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try			66
again. IF THE CONNECTORS ARE NOT CON-
			77
NECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS	66
TURNED ON.			Tie
	77		107
7. Insert the Wire Harness (77) and the Console	7
Wire (66) into the Right Upright (107).
		Console
Set the console assembly on the Left Upright		Assembly
(84) and the Right Upright (107). Be careful to
avoid pinching the wires. While a second per-
son holds the console assembly, attach it to the
Uprights with four Console Bolts (64) and four
Star Washers (8) as shown; start all four
Console Bolts and then firmly tighten them.			77, 66
Plug in the power cord as described on page			8
11, and turn on the power as described on page			8
13. Note: The treadmill may automatically rise to
			64
the maximum incline level and then return to the			64
minimum level. Adjust the incline to the lowest			107
inline level as described in step 4 on page 14.			84
	8