ProForm PETL71707.0 Sleeve to make sure that it is locked into, Place, This step is completed

Page 10

11. Identify the Latch Assembly (55). Remove the

tie from the end of the tube. Make sure that the

sleeve has been slid over hole 1 and that the

Latch Knob (54) is locked into hole 1. Pull on

the sleeve to make sure that it is locked into

place.

11

54

Tube

Hole 1

12. Raise the Frame (53) to the position shown.

Have a second person hold the Frame until

this step is completed.

Orient the Latch Assembly (55) so that the large

barrel and the Latch Knob (54) are in the posi-

tions shown. Attach the Latch Bracket (68) to the

bracket on the Base (80) with two 3/8" x 2" Bolts

Sleeve

12

53

 

84

55

(4) and two 3/8" Nuts (8).

Attach the upper end of the Latch Assembly (55) to the bracket on the Frame (53) with a 3/8" x 2" Bolt (4) and a 3/8" Nut (8). Note: It may be nec- essary to move the Frame back and forth to align the Latch Assembly with the bracket. Lower the Frame (53) (see HOW TO LOWER THE TREADMILL FOR USE on page 18).

54 55

Large Barrel

68

80 84

13.Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread- mill. Keep the included hex key in a secure place; the hex key is used to adjust the walking belt (see pages

20 and 21).

10

Image 10
Contents QUESTIONS? Model No. PETL71707.0 Serial NoTable of Contents Important Precautions Page Before YOU Begin Make sure that the power cord is unplugged AssemblyRepeat this step on the other side Wheel must turn freely Not fully fold the Frame yet Careful not to pinch the Upright WireTighten the Bolts yet Do not overtighten the Nut the Base Wheel must turn freelyScrews and then tighten them Have a second person hold the Frame until Sleeve to make sure that it is locked intoPlace This step is completedTightened before using the power cord Operation and AdjustmentHOW to Plug in the Power Cord PRE-LUBRICATED Walking BeltConsole Diagram Features of the ConsoleHOW to USE the Manual Mode HOW to Turn on the PowerInsert the key into the console Time display-When When you are finished exercising, removeAdjust the incline of the treadmill to the lowest Distance/Incline disCustomize your workout if desired HOW to USE a Preset WorkoutSelect a preset workout Monitor your progress with the matrix and the displaysInformation Mode Optional Chest Pulse SensorHOW to Fold and Move the Treadmill HOW to Move the TreadmillHOW to Lower the Treadmill for USE Troubleshooting Problem The power turns off during useProblem The walking belt slows when walked on Problem Solution Workout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencyPart LIST-Model No. PETL71707.0 Key No. Qty DescriptionExploded Drawing A-Model No. PETL71707.0 R1207A Exploded Drawing B-Model No. PETL71707.0 R1207A Exploded Drawing C-Model No. PETL71707.0 R1207A Exploded Drawing D-Model No. PETL71707.0 R1207A Ordering Replacement Parts Recycling Information