ProForm PETL71707.0 manual Problem Solution

Page 21

PROBLEM:

SOLUTION:

The walking belt is off-center or slips when walked on a. If the walking belt is off-center, first remove the

key and UNPLUG THE POWER CORD. If the walking belt has shifted to the left, use the hex key to turn the left rear roller bolt clockwise 1/2 of a turn; if the walking belt has shifted to the right, turn the bolt counterclockwise 1/2 of a turn. Be careful not to overtighten the walking belt. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walk- ing belt is centered.

b. If the walking belt slips when walked on, first re- move the key and UNPLUG THE POWER CORD. Using the hex key, turn both rear roller bolts clock- wise, 1/4 of a turn. When the walking belt is cor- rectly tightened, you should be able to lift each side of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and carefully walk on the treadmill for a few minutes. Repeat until the walking belt is prop- erly tightened.

a

b

21

Image 21
Contents Model No. PETL71707.0 Serial No QUESTIONS?Table of Contents Important Precautions Page Before YOU Begin Assembly Make sure that the power cord is unpluggedRepeat this step on the other side Wheel must turn freely Tighten the Bolts yet Careful not to pinch the Upright WireNot fully fold the Frame yet Do not overtighten the Nut the Base Wheel must turn freelyScrews and then tighten them Place Sleeve to make sure that it is locked intoHave a second person hold the Frame until This step is completedHOW to Plug in the Power Cord Operation and AdjustmentTightened before using the power cord PRE-LUBRICATED Walking BeltFeatures of the Console Console DiagramHOW to Turn on the Power HOW to USE the Manual ModeInsert the key into the console Adjust the incline of the treadmill to the lowest When you are finished exercising, removeTime display-When Distance/Incline disSelect a preset workout HOW to USE a Preset WorkoutCustomize your workout if desired Monitor your progress with the matrix and the displaysOptional Chest Pulse Sensor Information ModeHOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingProblem The walking belt slows when walked on Problem Solution Exercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencyKey No. Qty Description Part LIST-Model No. PETL71707.0Exploded Drawing A-Model No. PETL71707.0 R1207A Exploded Drawing B-Model No. PETL71707.0 R1207A Exploded Drawing C-Model No. PETL71707.0 R1207A Exploded Drawing D-Model No. PETL71707.0 R1207A Recycling Information Ordering Replacement Parts