ProForm PETL71707.0 manual HOW to Fold and Move the Treadmill, HOW to Move the Treadmill

Page 17

HOW TO FOLD AND MOVE THE TREADMILL

HOW TO FOLD THE TREADMILL FOR STORAGE Before folding the treadmill, adjust the incline to the lowest position. If you do not do this, you may damage the treadmill when you fold it. Remove the key and unplug the power cord. CAUTION: You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.

1.Hold the metal frame firmly in the location shown by the arrow at the right. CAUTION: To decrease the pos- sibility of injury, do not lift the frame by the plastic foot rails. Make sure to bend your legs and keep your back straight as you raise the frame. Raise the frame about halfway to the vertical position.

2.Raise the frame until the latch knob locks into the storage position. Make sure that the latch knob is locked in the storage position.

To protect the floor or carpet from damage, place a mat under the treadmill. Keep the treadmill out of di- rect sunlight. Do not leave the treadmill in the stor- age position in temperatures above 85° F (30° C).

HOW TO MOVE THE TREADMILL

Before moving the treadmill, convert the treadmill to the stor- age position as described above. Make sure that the latch knob is locked in the storage position.

1.Hold a handrail and the frame and place one foot against one of the wheels.

2.Tilt the treadmill back until it rolls freely on the wheelsNever. Carefully move the treadmill to the desired location. move the treadmill without tipping it back. To reduce the risk of injury, use extreme caution while moving the treadmill. Do not attempt to move the treadmill over an uneven surface.

3.Place one foot against a wheel, and carefully lower the treadmill until it is resting in the storage position.

Frame

Latch Knob

Frame

Handrail

Wheels Base

17

Image 17
Contents Model No. PETL71707.0 Serial No QUESTIONS?Table of Contents Important Precautions Page Before YOU Begin Repeat this step on the other side AssemblyMake sure that the power cord is unplugged Wheel must turn freely Tighten the Bolts yet Careful not to pinch the Upright WireNot fully fold the Frame yet Do not overtighten the Nut the Base Wheel must turn freelyScrews and then tighten them Place Sleeve to make sure that it is locked intoHave a second person hold the Frame until This step is completedHOW to Plug in the Power Cord Operation and AdjustmentTightened before using the power cord PRE-LUBRICATED Walking BeltFeatures of the Console Console DiagramInsert the key into the console HOW to Turn on the PowerHOW to USE the Manual Mode Adjust the incline of the treadmill to the lowest When you are finished exercising, removeTime display-When Distance/Incline disSelect a preset workout HOW to USE a Preset WorkoutCustomize your workout if desired Monitor your progress with the matrix and the displaysOptional Chest Pulse Sensor Information ModeHOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingProblem The walking belt slows when walked on Problem Solution Exercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencyKey No. Qty Description Part LIST-Model No. PETL71707.0Exploded Drawing A-Model No. PETL71707.0 R1207A Exploded Drawing B-Model No. PETL71707.0 R1207A Exploded Drawing C-Model No. PETL71707.0 R1207A Exploded Drawing D-Model No. PETL71707.0 R1207A Recycling Information Ordering Replacement Parts