ProForm PETL71707.0 manual Wheel must turn freely

2.With the help of a second person, carefully tip the treadmill onto its left side. Partially fold the Frame (53) so that the treadmill is more stable; do not fully fold the Frame yet.

Cut the tie securing the Upright Wire (78) to the Base (80). Locate the tie in the indicated hole in the Base, and use the tie to pull the Upright Wire out of the hole.

Attach a Base Pad (79) to the Base (80) in the location shown with a Base Pad Spacer (25) and a 1" Tek Screw (56). Then, attach another Base Pad (79) with only a 1" Tek Screw (56).

3.Attach a Base Wheel (81) with the 3/8" x 2" Bolt

(4) and the 3/8" Nut (8) that you removed in step 1. Do not overtighten the Nut; the Base

Wheel must turn freely.

Cut the tie off the Upright Wire (78).

4.Identify the Right Upright (72) and the Right Upright Spacer (74), which are marked with stickers. Insert the Upright Wire (78) through the Right Upright Spacer as shown.

See the inset drawing. Tie the wire tie in the Right Upright (72) securely around the end of the Upright Wire (78). With the help of a second person, hold the Right Upright near the Base (80). Then, pull the other end of the wire tie until the Upright Wire is routed completely through the Right Upright.

2
	80	Hole		78
53				79
			56
				Tie
25 79	56
3		78Tie
4
	8	81
4		Tie	72
78				78
		80		74

	72
	Wire
78	Tie

7