THE INFORMATION MODE
The console features an information mode that keeps track of the total distance that the walking belt has moved and the total number of hours that the treadmill has been used. The information mode also allows you to switch the console from kilometers to miles. In addi- tion, the information mode allows you to turn on and turn off the display demo mode.
To select the information mode, hold down the Stop button while inserting the key into the console and then release the Stop button. When the information mode is selected, the following information will be shown:
An “M” for metric kilometers or “E” for English miles will appear in the Calories/Pulse display. Press the speed in- crease button to change the unit of measurement if de- sired.
The Distance/Incline display will show the total number of kilometers (or miles) that the walking belt has moved.
The Time display will show the total number of hours
the treadmill has been used.
Note: The console features a display demo mode, de- signed to be used if the treadmill is displayed in a store. While the demo mode is turned on, the console will function normally when you plug in the power cord, switch the circuit breaker to the reset position, and in- sert the key into the console. However, when you re- move the key, the displays will remain lit, although the buttons will not function. If the demo mode is turned on, a “d” will appear in the speed display while the in- formation mode is selected. To turn on or turn off the demo mode, press the speed decrease button.
To exit the information mode, remove the key from the console.
THE OPTIONAL CHEST PULSE SENSOR
An optional chest pulse sensor offers
To purchase the optional chest pulse sensor, call the telephone number on the front cover of this manual.
If you purchase the optional chest pulse sensor, follow the steps below to install the receiver in- cluded with the chest pulse sensor.
1.Make sure that the power cord is unplugged. Remove the indicated 1/2" Screws (1) and the Access Door (93) from the Console Back (91).
2.Connect the wire on the receiver (A) to the indi- cated wire extending from the Console Back (91).
Hold the receiver so the small cylinder is ori- ented as shown and is facing the Console Back. Attach the receiver to the plastic posts on the Access Door (93) with the two included small screws.
3.Make sure that no wires are pinched. Reattach the Access Door (93) with the 1/2" Screws (1). Discard the other wires included with the receiver.
| 91 | Wire |
93 |
| Small |
| Screws | |
1 Small |
| |
Cylinder | A | |
|
| |
16