ProForm PETL71707.0 manual Screws and then tighten them

Page 9

8.Have a second person hold the console assem- bly near the Right Upright (72). Remove the wire

tie from the Upright Wire (78).

Connect the Upright Wire (78) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CON-

NECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Then, insert the connectors into the Right Upright (72).

Set the console assembly on the Right Upright

(72)and the Left Upright (not shown). Attach the console assembly with four 5/16" x 1" Bolts (5) and four 5/16" Star Washers (7) (only two are shown); start all four Bolts and then tighten them.

9.Insert the Book Rack (84) into the console as- sembly; it may be helpful to rock the Book Rack up and down as you insert it. Attach the Book Rack with eight 3/4" Screws (10); start all eight

Screws and then tighten them.

See steps 5 and 7. Tighten the 3/8" x 4" Bolts

10.If necessary, press the Left Tray (86) and the Right Tray (85) into the top of the console as- sembly.

	8
	Console	Console
	Wire	Console	Console
	78	Assembly	Console
	78	Assembly	Wire
	7
	5	7	78
	72	7	78
	72	5
		Wire Tie

9	84		Console Assembly
	84		Console Assembly
	10	10	10
10	86
Console	86
Assembly
			85

9

Image 9

Contents Model No. PETL71707.0 Serial No QUESTIONS?Table of Contents Important Precautions Page Before YOU Begin Assembly Make sure that the power cord is unpluggedRepeat this step on the other side Wheel must turn freely Tighten the Bolts yet Careful not to pinch the Upright WireNot fully fold the Frame yet Do not overtighten the Nut the Base Wheel must turn freelyScrews and then tighten them Place Sleeve to make sure that it is locked intoHave a second person hold the Frame until This step is completedHOW to Plug in the Power Cord Operation and AdjustmentTightened before using the power cord PRE-LUBRICATED Walking BeltFeatures of the Console Console DiagramHOW to Turn on the Power HOW to USE the Manual ModeInsert the key into the console Adjust the incline of the treadmill to the lowest When you are finished exercising, removeTime display-When Distance/Incline disSelect a preset workout HOW to USE a Preset WorkoutCustomize your workout if desired Monitor your progress with the matrix and the displaysOptional Chest Pulse Sensor Information ModeHOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingProblem The walking belt slows when walked on Problem Solution Exercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencyKey No. Qty Description Part LIST-Model No. PETL71707.0Exploded Drawing A-Model No. PETL71707.0 R1207A Exploded Drawing B-Model No. PETL71707.0 R1207A Exploded Drawing C-Model No. PETL71707.0 R1207A Exploded Drawing D-Model No. PETL71707.0 R1207A Recycling Information Ordering Replacement Parts