13.Partially tighten two M8 x 25mm Bolts (4) with two M8 Star Washers (9) into the Left Upright (79) and the Left Handrail (21); do not fully tighten the Bolts yet.
Next, partially tighten two M8 x 25mm Bolts (4) with two M8 Star Washers (9) into the Right Upright (80) and the Right Handrail (100). Then, tighten all four Bolts.
See steps 5 and 8. Tighten the M10 x 96mm Bolts (7).
14.Remove the Resistance Knob (88) from a resis- tance mechanism. Make sure that the 3/8" x 4 3/4" Bolt (3) stays inside the resistance mechanism and that the resistance mecha- nism does not come apart. Note: See the lower drawing to reassemble the resistance mechanism if necessary.
Apply a small amount of the included grease around the Resistance Cone (85) and Upright Insert (84).
Insert the Resistance Cone (85) into the Upright Insert (84) in the Left Upright (79), with the two large holes on top as shown. Then, tighten the Resistance Knob (88) onto the 3/8" x 4 3/4" Bolt
(3). Do not fully tighten the Resistance Knob.
Attach the other resistance mechanism to the Right Upright (80) as described above.
13 |
|
|
|
| Console |
|
|
|
|
|
| Assembly |
|
21 |
|
|
|
|
|
|
4 | 9 | 9 | 4 |
| 9 | 4 |
| 79 |
|
| 100 | ||
|
|
|
| 4 | 9 | 80 |
|
|
|
|
| ||
14 |
|
| 79 |
|
|
|
| 88 |
| Large |
| 80 | |
|
| 84 |
| |||
|
|
| Holes |
| ||
|
|
| 85 | Resistance |
| |
|
|
| Mechanism |
| ||
|
|
|
| 3 |
|
|
Large
Holes
88
3
12