ProForm How to Fold and Move a Treadmill: A Complete Guide

Page 20

HOW TO FOLD AND MOVE THE TREADMILL

HOW TO FOLD THE TREADMILL FOR STORAGE Before folding the treadmill, adjust the incline to the lowest position. If you do not do this, you may damage the treadmill when you fold it. Remove the key and unplug the power cord. CAUTION: You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.

1.Hold the metal frame firmly in the location shown by the arrow at the right. CAUTION: To decrease the pos- sibility of injury, do not lift the frame by the plastic foot rails. Make sure to bend your legs and keep your back straight as you raise the frame. Raise the frame about halfway to the vertical position.

2.Raise the frame until the latch knob locks into the storage position. Make sure that the latch knob is locked in the storage position.

To protect the floor or carpet from damage, place a mat under the treadmill. Keep the treadmill out of di- rect sunlight. Do not leave the treadmill in the stor- age position in temperatures above 85° F (30° C).

HOW TO MOVE THE TREADMILL

Before moving the treadmill, convert it to the storage position as described above. Make sure that the latch knob is locked in the storage position.

1.Hold a handrail and the frame, and place one foot against one of the wheels.

2.Tip the treadmill back until it rolls freely on the wheels. Carefully move the treadmill to the desired location.

Never move the treadmill without tipping it back. To reduce the risk of injury, use extreme caution while moving the treadmill. Do not attempt to move the treadmill over an uneven surface.

3.Place one foot against a wheel, and carefully lower the treadmill until it is resting in the storage position.

Frame

Frame

Latch

Knob

Frame

Handrail

Wheels

20

Image 20
Contents QUESTIONS? Model No. PFTL99909.0 Serial NoMon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT On the WEBTable of Contents Important Precautions Cord immediately after use, before cleaning Before YOU Begin Assembly Page Touch the Upright do not fully tighten Bolts yet Ful not to pinch the Wire HarnessDo not overtighten the Locknut the Wheel Must turn freely Do not fully fold the Frame yet Do not overtighten the Locknut Wheel must turn freelyTighten the Bolts yet Turned on Be Damaged When the Power isNected PROPERLY, the Console MAY See steps 5 and 8. Tighten the M10 x 96mm Bolts Attach the other Cross Walk Arm 82 as de- scribed above PRE-LUBRICATED Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord Console Diagram Features of the ConsoleInsert the key into the console HOW to Turn on the PowerHOW to USE the Manual Mode Measure your heart rate if desired Turn on the fan if desiredHOW to USE a Preset Workout Information Mode HOW to USE the Cross Walk ArmsHOW to Fold and Move the Treadmill HOW to Move the TreadmillHOW to Lower the Treadmill for USE Troubleshooting Problem The power does not turn onProblem The power turns off during use Compatible with GFCI-equipped outletsProblem The walking belt slows when walked on TopProblem Solution Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyR0209A Key No. Qty. DescriptionDescription Exploded Drawing A-Model No. PFTL99909.0 R0209A Exploded Drawing B-Model No. PFTL99909.0 R0209A Exploded Drawing C-Model No. PFTL99909.0 R0209A Exploded Drawing D-Model No. PFTL99909.0 R0209A Icon Health & Fitness, Inc., 1500 S W., Logan, UT Ordering Replacement PartsLimited Warranty