8. | Hold a Bolt Spacer (98) inside the lower end of | 8 |
|
|
|
|
| the Left Upright (79). Insert an M10 x 96mm Bolt |
|
|
|
| |
| (7) with an M10 Star Washer (8) into the Left |
|
| 7 |
| 79 |
| Upright and the Bolt Spacer. Repeat this step |
|
|
| ||
| with a second Bolt Spacer (98), M10 x 96mm |
|
| 8 |
|
|
| Bolt (7), and M10 Star Washer (8). |
|
|
|
| |
| Orient the Left Upright (79) and the Left Upright |
|
|
|
|
|
| Spacer (89) as shown. Hold the Left Upright |
| 98 |
|
|
|
| Spacer and the Left Upright against the Base |
| 89 |
|
| |
| (99). Tighten the M10 x 96mm Bolts (7) until the |
|
|
|
| |
| heads of the Bolts touch the Upright; do not fully |
|
| 99 |
|
|
| tighten the Bolts yet. |
|
|
|
| |
9. | Press a Base Cap (91) into the Base (99). | 9 |
|
|
|
|
| With the help of a second person, tip the treadmill |
| 91 |
|
|
|
| so that the Base (99) is flat on the floor. |
|
|
|
| |
|
|
| 99 |
|
|
|
10. | Set the console assembly face down on a soft | 10 |
|
|
| Console |
| surface to avoid scratching the console assem- | 100 |
| 1 | ||
| bly. |
|
| Wire | ||
| Identify the Right Handrail (100) which is |
|
| 39 |
| 1 |
| marked with a sticker. Hold the Right Handrail |
| Console |
| ||
| near the console assembly. Attach the console |
|
|
| Large Hole | |
| ground wire to the Right Handrail with a #8 x |
| Ground Wire |
| ||
| 1/2" Ground Screw (29). | Console |
|
| 1 | |
| Next, insert the console wire into the large hole | Assembly |
|
| ||
| in the Right Handrail (100) and pull it out of the |
|
|
| 29 |
|
| top as shown. Attach the Right Handrail with |
|
|
|
| |
| three #8 x 3/4" Screws (1). Make sure that no |
|
|
|
|
|
| wires are pinched. Start all three Screws be- |
|
|
|
|
|
| fore tightening any of them; do not over- |
|
|
|
|
|
| tighten the Screws. |
|
|
|
|
|
| Remove the ties from the M8 Cage Nuts (39). If |
|
|
|
|
|
| necessary, press the Cage Nuts back into place. | 10 |
|
|
|
|
|
|
|
|
|
| |