ProForm 590 lt user manual Cord immediately after use, before cleaning

Page 4

19. Never leave the treadmill unattended while it

23. Inspect and properly tighten all parts of the

is running. Always remove the key, unplug

treadmill regularly.

the power cord, and switch the reset/off cir-

24. DANGER: Always unplug the power

cuit breaker to the off position when the

treadmill is not in use. (See the drawing on

cord immediately after use, before cleaning the

page 5 for the location of the circuit breaker.)

treadmill, and before performing the mainte-

20. Do not attempt to raise, lower, or move the

nance and adjustment procedures described in

this manual. Never remove the motor hood un-

treadmill until it is properly assembled. (See

less instructed to do so by an authorized ser-

ASSEMBLY on page 6, and HOW TO FOLD

vice representative. Servicing other than the

AND MOVE THE TREADMILL on page 20.)

procedures in this manual should be performed

You must be able to safely lift 45 lbs. (20 kg)

by an authorized service representative only.

to raise, lower, or move the treadmill.

25. This treadmill is intended for in-home use

21. When folding or moving the treadmill, make

only. Do not use this treadmill in a commer-

sure that the storage latch is holding the

cial, rental, or institutional setting.

frame securely in the storage position.

 

22. Never insert any object into any opening on

the treadmill.

SAVE THESE INSTRUCTIONS

 

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents QUESTIONS? Model No. PFTL99909.0 Serial NoMon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT On the WEBTable of Contents Important Precautions Cord immediately after use, before cleaning Before YOU Begin Assembly Page Do not overtighten the Locknut the Wheel Must turn freely Ful not to pinch the Wire HarnessTouch the Upright do not fully tighten Bolts yet Do not fully fold the Frame yet Do not overtighten the Locknut Wheel must turn freelyTighten the Bolts yet Nected PROPERLY, the Console MAY Be Damaged When the Power isTurned on See steps 5 and 8. Tighten the M10 x 96mm Bolts Attach the other Cross Walk Arm 82 as de- scribed above HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to USE the Manual Mode HOW to Turn on the PowerInsert the key into the console Measure your heart rate if desired Turn on the fan if desiredHOW to USE a Preset Workout Information Mode HOW to USE the Cross Walk ArmsHOW to Fold and Move the Treadmill HOW to Move the TreadmillHOW to Lower the Treadmill for USE Troubleshooting Problem The power does not turn onProblem The power turns off during use Compatible with GFCI-equipped outletsProblem The walking belt slows when walked on TopProblem Solution Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyR0209A Key No. Qty. DescriptionDescription Exploded Drawing A-Model No. PFTL99909.0 R0209A Exploded Drawing B-Model No. PFTL99909.0 R0209A Exploded Drawing C-Model No. PFTL99909.0 R0209A Exploded Drawing D-Model No. PFTL99909.0 R0209A Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT
Top Page Image Contents