PROBLEM:
SOLUTION:
PROBLEM:
SOLUTION:
The walking belt is
key and UNPLUG THE POWER CORD. If the walking belt has shifted to the left, use the hex key to turn the left idler roller bolt clockwise 1/2 of a turn; if the walking belt has shifted to the right, turn the left idler roller bolt counterclockwise 1/2 of a turn. Be careful not to overtighten the walking belt. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walking belt is centered.
b. If the walking belt slips when walked on, first re- move the key and UNPLUG THE POWER CORD. Using the hex key, turn both idler roller bolts clock- wise, 1/4 of a turn. When the walking belt is cor- rectly tightened, you should be able to lift each side of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and carefully walk on the treadmill for a few minutes. Repeat until the walking belt is prop- erly tightened.
The cross walk arms squeak during use
a. (Note: Correcting this problem requires a small amount of white marine grease, available at hard- ware stores.) Turn the Resistance Knob (88) coun- terclockwise and remove it. Next, remove the Resistance Cone (85) with the Cross Walk Arm (82).
Apply a thin layer of white marine grease to the outer surface of the Resistance Cone (85). Then, reattach the Resistance Cone with the Cross Walk Arm (82) and the Resistance Knob (88).
a
b |
a |
| |
88 | 82 | |
85 | ||
|
24