15.Insert the end of a Cross Walk Arm (82) into the hole in the top of a resistance mechanism.
Make sure that the bend in the Cross Walk Arm is positioned as shown.
Tighten the #10 x 3/4" Screw (114) into the re- sistance mechanism and Cross Walk Arm (82) from the direction shown. Press a Small Cap (13) into the hole for the Screw.
Attach the other Cross Walk Arm (82) as de- scribed above.
16.Raise the Frame (57) to the position shown.
Have a second person hold the Frame until this step is completed.
Orient the Storage Latch (54) so that the large barrel and the Latch Knob (55) are in the posi- tions shown.
Attach the upper end of the Storage Latch (54) to the Frame (57) with a 3/8" x 1 1/2" Bolt (5). Attach the lower end of the Storage Latch (54) to the Base (99) with a 3/8" x 1 3/4" Bolt (6). Note: It may be necessary to move the Frame (57) back and forth to align the Storage Latch with the Base.
Lower the Frame (57) (see HOW TO LOWER THE TREADMILL FOR USE on page 21).
15 |
|
|
|
| Bend |
| 82 |
|
Hole | 114 | 13 |
|
| |
Resistance |
| 82 |
Mechanism |
| Resistance |
|
| Mechanism |
|
| 114 |
|
| 13 |
16 | 5 |
|
57 |
| |
|
| |
|
| 54 |
|
| 55 |
Large |
|
|
Barrel |
|
|
99 | 6 | |
|
| |
17.Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread- mill. Keep the included hex keys in a secure place; one of the hex keys is used to adjust the walking belt (see pages 23 and 24).
13