ProForm PFBE64490 manual Adjusting the Weight Bench, Adjusting the Backrest

Page 13

Adjusting the Weight Bench

This section explains how to adjust the weight bench. See the EXERCISE GUIDELINES on page 17 for impor- tant information on how to get the most benefit from your exercise program. Also, refer to the accompanying exercise poster to see the correct form for each exercise.

Inspect and tighten all parts each time you use the weight bench. Replace any worn parts immediately. The weight bench can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents.

ADJUSTING THE BACKREST

The Backrest (15) can be set to four different positions: a level position, two decline positions and an incline posi- tion.

To change the position of the Backrest (15), move the Adjustment Tube (29) to a different set of adjustment brackets in the Uprights (1, 37). To set the Backrest (15) to the lowest decline position, remove the Adjustment Tube (29) and lower the Backrest directly onto the Crossbar (20).

USING THE WEIGHT RESTS AND SAFETY SPOTTERS

Before beginning an exercise, insert the Weight Rests (21, 58) and the Safety Spotters (56, 57) into the holes in the Uprights (1, 37) that are best suited for the exercise. The selected holes should be at the lowest point to which you want your barbell to go during the exercise. Perform the exercise as shown on the accompanying exercise poster. Note: Make sure that the locking clips are hooked around the Uprights.

Important: The Safety Spotters (56, 57) are designed to be safety devices. Their primary function is to min- imize the risk of injury if the barbell is dropped during standing exercises. The Safety Spotters are deliber- ately designed to bend when hit with a barbell loaded with heavy weights. This minimizes the risk of the barbell bouncing off the Safety Spotters and causing injury to the user. If you accidentally bend the Safety Spotters, please call our Customer Service Department (see the front cover of this manual) to order replacement Safety Spotters.

WARNING: Always set both weight rests and both safety spotters at the same height.

1

37

 

 

15

 

29

 

20

21

1

 

 

37

56

 

 

58

 

57

13

Image 13
Contents Customer HOT Line Model No. PFBE64490 Serial NoMon.ÐFri., 6 a.m.Ð6 p.m. MST Table of Contents Important Precautions Left Side Before You BeginRight Side Part Identification ChartÑModel No. PFBE64490 R0999A Assembly Crossbar is turned so the decal is facing up While a second person holds the Right UprightTighten all M10 Nylon Locknuts used in steps 1 through Tighten the M6 x 63mm Screw Do not tighten the Screw yetPage Make sure that the Weight Carriage is oriented as shown Make sure that both Weight Rests are at the same height Adjusting the Backrest Adjusting the Weight BenchUsing the Weight Rests and Safety Spotters Adjusting the PAD Tube Make sure that you fully tighten the Adjustment KnobAttaching Weights to the LEG Lever Attaching the Curl Post or LAT TowerAttaching Weights to the Weight Carriage Adjusting the Bench for Squat ExercisesAttaching the LAT BAR to the LAT Tower Exercise Guidelines Cooling Down Muscle ChartStaying Motivated Date Exercise Weight Sets RepsAerobic Exercise Thursday Aerobic Exercise DateQty Description Part ListÑModel No. PFBE64490Exploded DrawingÐModel No. PFBE64490 Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT