ProForm PFEL54930 user manual Measure your heart rate if desired, Plas, Metal, Off the plastic

Page 13
Lower Button

The lower sec- tion of the large display

will show your pedaling speed,

your pedaling

pace (in RPM), and the resistance level. The dis- play will change from one number to the other every few seconds.

To view only your pedal- ing speed, your pedaling pace, or the resistance level, press the lower but- ton on the left side of the

large display until only the

word SPEED, RPM, or RESISTANCE appears;

make sure that the word SCAN does not appear.

To again view your pedaling speed, your pedaling pace, and the resistance level, press the lower button until the word SCAN reappears.

To reset the displays, press the On/Reset button.

Note: The console can show speed and dis-

 

tance in either miles or kilometers.

The letters

MPH or KM/H will appear in the lower section of

 

the large display to show which unit of measure-

 

ment is selected. To change the unit of measure-

 

ment, select the console’s information mode by

 

holding down the Program button for a few sec-

 

onds.

 

When the infor-

 

mation mode is

 

selected, the

 

upper section of

 

the large display

 

will show the

 

total distance

 

pedaled on the

 

elliptical

 

crosstrainer. The

 

center of the large display will show the total num-

 

ber of hours that the elliptical crosstrainer has

 

been used. The lower section of the large display

 

will show an E for English miles or an M for metric

 

kilometers. To change the unit of measurement,

 

press the Resistance + button.

 

To exit the information mode, press the On/Reset button.

5 Measure your heart rate if desired.

If there are thin

 

sheets of

plas-

 

tic on the

metal

 

contacts on the

 

handgrips, peel

Metal

off the plastic.

To use the hand-

Contacts

grip pulse sen-

 

sor, hold the

 

handgrips with your palms resting against the

metal contacts.

Avoid moving your hands.

When your pulse is detected, the heart-shaped indicator in the large display will flash each time your heart beats. After a moment, two dashes (– –) will appear and then your heart rate will be shown.

For the most accurate heart rate reading, continue to hold the handgrips for about 30 seconds. Note: When you first hold the handgrips, the large dis- play will show your heart rate continuously for 30 seconds. The display will then show your heart rate along with other feedback modes.

6 Turn on the fan if desired.

To turn on the

 

fan at low speed,

 

press the fan

 

button. To turn

Thumb

on the fan at

Wheel

high speed,

Fan

press the fan

Button

button a second

 

time. To turn off

the fan, press the fan button a third time. Note: If the pedals are not moved for about thirty sec- onds, the fan will automatically turn off.

Rotate the thumb wheel on the right side of the console to pivot the fan to the desired angle.

When you are finished exercising, the console

7 will automatically turn off.

If the pedals are not moved for a few seconds,

the displays will pause and the time will flash in the large display.

If the pedals are not moved and the console but- tons are not pressed for a few minutes, the con- sole will turn off.

13

Image 13
Contents Model No. PFEL54930 Serial No QUESTIONS?Through Customer HOT LineTable of Contents Down When you stop exercising, allow the pedals Important PrecautionsElliptical crosstrainer is intended for Hold the handgrip pulse sensor or the hanBack Before YOU BeginWrench A rubber mallet AssemblyRamp is turned as shown Wire Harnesses Lower Wire HarnessMake sure Wire harnesses 2Make. sure that the concave end of the FrameApply a generous amount of grease to the Pivot Axle Make sure thatTighten both Shoulder Screws at the same time Elliptical crosstrainer 114HOW to Plug in the Power Cord HOW to USE the Elliptical CrosstrainerHOW to Exercise on the Elliptical Crosstrainer To use a Smart program Features of the ConsoleUse HOW to USE the Manual Mode Plas Measure your heart rate if desiredMetal Off the plasticHOW to USE a Smart Program HOW to Connect Your Portable Stereo HOW to Connect Your CD PLAYER, VCR Or ComputerAudio Cable HOW to Connect Your Computer HOW to Connect Your Home StereoPhones jack, see instruction B HOW to Connect Your VCR Toll-free ProgramsPressVCR. the play button on your CD player or To Connect Your Computer on page 17. HOW to USE Programs Directly from OUR WEB SiteFollow the steps below to use a program from our Web site Return to the elliptical crosstrainer and begin PedalingHandgrip Pulse Sensor Troubleshooting HOW to Level the Elliptical CrosstrainerUse alcohol, abrasives, or chemicals Exercise Intensity Conditioning GuidelinesWorkout Guidelines Exercise FrequencyQty Description 109 R0903A100 108 102 101 101 102 104Limited Warranty HOW to Order Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT Part No R0903A