ProForm PFEL45012 user manual HOW to USE a Smart Program, Select one of the six Smart programs

Increase Arrow

HOW TO USE A SMART PROGRAM

1	Turn on the console.
	Refer to step 1 on page 12.
	Select one of the six Smart programs.
2
	Each time the
	console is turned
	on, the manual
	mode will be
	selected. To
	select a Smart
	program, press
	the Program but-
	ton repeatedly until the number 1, 2, 3, 4, 5, or 6
	appears in the upper right corner of the display.
	The profiles numbered 1 through 6 on the left
	side of the console show the resistance and pace
	settings for the Smart programs. For example,
	profile number 3 shows that when Smart program
	3 is selected, both the resistance and the pace
	will gradually increase during the first half of the
	program, and then decrease during the last half.
	Start the program.
3
	To start the program, simply begin exercising.
	Each Smart program consists of either twenty or
	thirty, one-minute periods. One resistance setting
	and one pace setting are programmed for each
	period. (The same resistance setting and/or pace
	setting may be programmed for consecutive peri-
	ods.)
	During the program, the resistance of the elliptical
	crosstrainer will automatically change as shown
	by the applicable profile on the console. If the cur-
	rent resistance level is too high or too low, you
	can change the resistance level by pressing the +
	and – buttons. However, when the current period
	of the program is completed, the resistance level
	will automatically	change if a different resistance

setting is programmed for the next period.

The pace set-

tings for the pro- gram will be shown by the right bar graph in the display. (The left bar graph will

show your actual

exercise pace.) As the right bar graph changes during the program, simply increase or decrease your pace so that the same number of bars appear on both bar graphs. If your pace is slower than the current pace setting, the increase arrow will appear in the display to prompt you to increase your pace; if your pace is faster than the pace setting, the decrease arrow will appear.

Important: The pace settings for the program are intended only to provide a goal. Your actu- al pace may be slower than the pace settings, especially during the first few months of your exercise program. Make sure to exercise at a pace that is comfortable for you.

During the program, the display will show the time remaining in the program. When no time remains, the program will be completed. If you continue exercising after the program is completed, the display will continue to show your exercise feed- back.

4 Follow your progress with the feedback modes.

Refer to step 4 on page 12.

5 Measure your heart rate if desired.

See step 5 on page 12.

6	When you are finished exercising, the console
	will automatically turn off.
	Refer to step 6 on page	12.

13