ProForm PFCG2224.0 user manual Repeat this process with the preassem Bled Small Seat Wheel

3. Orient the Seat (14) as shown. Attach the Seat to		3
	the Seat Carriage (13) with four M6 x 16mm
				14				Wide
	Screws (55).
								End
				13
						55		55
4. Pull the Seat Pin (18) out of the Seat Carriage		4
	(13) and turn it 90 degrees (see inset drawing B).
				14
	Set the Seat Carriage on the Rail (4) so that the
	Seat Pin is on the same side as the adjustment
	holes and the preassembled Small Seat Wheel
	(not shown) is under the Rail.			18				66
	Insert the barrel of an M10 x 22mm Bolt Set (66)			13
	into the Small Seat Wheel (40) as shown in inset						40
	drawing A.		Adjustment			66
				Holes
	Have a second person press down on the Seat				4
	(14). Hold the Small Seat Wheel (40) against the
	bottom of the Rail (4). Make sure that the wide
	side of the Wheel is held flat against the Rail
	(see inset drawing B). Attach the Wheel to the
	Seat Carriage (13) with the M10 x 22mm Bolt Set
	(66). Repeat this process with the preassem-						B
	bled Small Seat Wheel.
	Pull the Seat Pin (18) out and rotate it 90	A	Wide	40	Flush
			Side		Edges
	degrees. Engage the Seat Pin into an adjustment							4
			66
	hole in the Rail (4).						18	13
								40
5.	Attach the Handlebar (10) to the end of the Rail	5
	(4), inside the Side Shields (16, 17), with four M6						10
								53
	x 38mm Button Screws (53). Attach the Shield
	Cover (43) to the Handlebar with an M4 x 25mm
	Round Head Screw (47).
							16	47
							4	43
								17
		6