Assembly

Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

Assembly requires the included tools and your own adjustable wrench		and Phillips
screwdriver	.

Use the drawings below to identify the small parts used for assembly. The number in parenthesis below each drawing is the key number of the part, from the PART LIST on page 21. The number following the key number is the quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a part is not in the parts bag, check to see if it has been pre-assembled. If a part is missing, call toll-free1-888-533-1333.

M6 Washer		M8 Split	M8 Nylon	M10 Nylon	M4 x 12mm	M4 x 20mm
(66)–4	Washer (55)–9		Locknut (49)–4	Locknut (72)–4	Screw (41)–6	Screw (56)–1
M6 x 16mm Button		M6 x 20mm Button		M8 x 19mm Button	M8 x 38mm
Screw (8)–4		Screw (63)–3		Screw (40)–5	Button Bolt (58)–4
M8 x 16mm Button			M10 x 112mm Carriage Bolt (76)–4
Screw (61)–4			M10 x 112mm Carriage Bolt (76)–4
Screw (61)–4

1.Orient the Rear Stabilizer (16) as shown. While another person lifts the Frame Rail (52), attach the Rear Stabilizer to the Leg (20) with two M10 x 112mm Carriage Bolts (76) and two M10 Nylon Locknuts (72).

1		52
		52
	76	20
	76	16
		16
		72