•Software Version – press ENTER to select Console Software Version
Console Software Part Number Console Software Build Date
•Floor Model – disables Power Save Selection options are On or Off Default is Off (Power Save On)
•Belt Lube Timer (treadmill only)
Tracks the total hours of workout and cool down time since the last belt lubrication. When the timer reaches 75 hours it triggers a reminder message during every workout.
Press and hold the DOWN arrow key for 5 seconds to reset the time.
Lubricating the Walking Belt
1.Turn the treadmill off with the ON / OFF switch and then unplug the power cord from the outlet.
2.Loosen the rear roller adjustment bolts approximately 10 full turns. Be sure to note how many turns you have rotated the screws since this is how many turns you will tighten them at the end of this procedure.
3.Using the Silicon lubricant approved by Life Fitness, apply one half of the bottle to the surface of the deck between the belt and the deck. Try to apply the majority of the lubricant to the center of the deck.
4.Visually make sure the walking belt is centered on the deck and then tighten the rear roller adjustment bolts the same number of turns as when you loosened them.
5.Plug the treadmill in and turn on the ON / OFF switch.
6.Run the treadmill at 3 mph / 5 kph and check that the belt runs centered. If not, see How to Adjust and Tension the Striding Belt in the base model’s Owner’s Manual.
7.Reset the LUBRICATE WALKING BELT message on the console. To reset the message enter the Settings Menu. Scroll to the Message: HOURS SINCE BELT LUBRICATION = XXXX. Press and hold the DOWN arrow key for 10 seconds to reset the lubrication timer.
25