Suunto None manual Gauge mode does not provide decompression information

Page 34

In the GAUGE mode, the total dive time is always displayed in minutes in the lower right corner. In addition, a Dive Timer in the center window displays time in minutes and seconds. The center window Dive Timer is activated at the start of the dive and it can be reset during the dive and used as a stopwatch by pressing the SELECT button.

	BY PRESSING THE SELECT BUTTON DURING A DIVE, A BOOKMARK
	IS WRITTEN IN THE PROFILE MEMORY, THE DIVE TIMER IS RESET,
	AND THE PREVIOUSLY-TIMED INTERVAL IS DISPLAYED BELOW.
NOTE	The GAUGE mode does not provide decompression information.
NOTE	There is no ascent rate monitoring in the GAUGE mode.
NOTE	If you dive with the GAUGE mode, it is not possible to change between
	the modes before the no fly time has counted down.

Image 34

Contents COBRA3 Time Tank pressure Before Diving Intellectual Property Welcome to the World of Suunto Diving Instruments Not for Professional USE! Suunto dive computers are Before DIVING. Make sure that you fully understand the useSerious injury or death That tend to increase the risk of decompression illness DCIDives That Require Decompression Stops are not Batteries. Recycle or dispose of used batteries properly Nitrox mode, as well as from AIR or Nitrox mode to GaugeMode even during the no-fly time Before the instrument has counted down the no-fly timeSuunto AT a Glance Button symbols and functionsSymbol Button Press Main functions Navigating in the menusDown Setting the time Time mode settingsSetting the alarm Setting the dateSetting the tones Setting the unitsSetting the backlight AC water contactsCompass display Learning how to use your compassDisplays by pressing the UP/DOWN buttons Locking a bearingCompass settings Symbol ExplanationCalibration Declination Time-outEmergency ascents Before DivingSuunto RGBM/Deep Stop Algorithm Dive computer limitationsPreset alarm types Alarm type Audible and visual alarmsAlarm type NitroxError conditions Alarm type Alarm reasonAlarm is activated Omitted decompressionSetting the depth alarm Connecting Suunto Cobra3 to a regulatorDive mode settings Setting the dive-time alarmBottom time, for example Setting the nitrox valuesSetting the personal/altitude adjustments Are stored until changedSetting the Rgbm values Setting the sample rateSetting the Safety Stops/Deep Stops Setting the tank pressure alarmDive mode activation Accessing Dive modeActivation and pre-checks Diving at altitude Battery power indicationAlt. adjustment value Altitude range How the Altitude value is setPersonal Condition Desired tables Adjustment Value Personal adjustmentsRgbm setting Desired Tables Effect Recommended Safety Stops Safety StopsMandatory Safety Stops Deep stops Order to perform the necessary dive pre-checks Diving in AIR mode DIVEairDiving Basic dive dataBookmark Tank pressure dataLow Air Pressure Warnings Ascent rate indicatorDecompression dives Ceiling, ceiling zone, floor and decompression range Display below the floorDisplay at the ceiling zone Display above the floorDisplay above the ceiling Default nitrox settings Diving in Nitrox mode DIVEnitroxBefore diving in Nitrox mode Oxygen displaysOxygen limit fraction OLF Diving in Gauge mode DIVEgaugeGas change and multiple breathing gas mixes There is no ascent rate monitoring in the Gauge mode Gauge mode does not provide decompression informationModes before the no fly time has counted down Surface interval Alarms Symbol on displayAfter Diving Dive numberingDive Planning mode PLANnodec Plan modeFlying after diving Dive numbering shown during dive planning Simulation Mode PLANsimulatorMode Dive SimulatorMemory mode Dive logbook MEMLogbookDive series if the no-fly time has not ended. See .2. Dive Providing that the battery has been replaced according toInstructions Numbering for further informationUnit and the downloadable Suunto Dive Manager software Suunto Dive Manager SDMPage Care and Maintenance of MY Suunto Diving Computer Water Contacts and Push ButtonsBattery replacement and strap kits must be used FAQsWarranty Replacing the battery Battery ReplacementBattery kit Required toolsBattery compartment lid, indicating a leak Technical Data Rgbm Suunto Rgbm adaptive decompressionDiver Attention Symbol Advice to Extend Surface Interval No-decompression limitsAltitude diving Oxygen exposureCopyright Trademark Intellectual PropertyPatent notice User’s responsibility Disclaimers12.2. CE Warranty Period Exclusions and LimitationsOther important notices Access to Suunto warranty serviceLimitation of Liability Page Disposal of the Device Glossary EAD EANNoaa Customer Service Contacts CopyrightTWO Year Warranty Suunto Oy 9/2008, 10/2008, 11/2008

The GAUGE mode does not provide decompression information.

There is no ascent rate monitoring in the GAUGE mode.

the modes before the no fly time has counted down.