JVC LVT1007-005A, RM-SRX7032U, 0303NHMMDWJEIN, RX-7032V manual Specifications, Audio, Video

Page 53

Specifications

Amplifier

 

 

Output Power

 

 

At Stereo operation

 

Front ch:

100 W* per channel, min. RMS, driven into 8 Ω,

 

1 kHz, with no more than 0.8% total harmonic

 

distortion. (IEC268-3/DIN)

 

At Surround operation:

 

Front ch:

100 W* per channel, min. RMS, driven into 8 Ω at

 

1 kHz, with no more than 0.8% total harmonic

 

distortion.

 

Center ch:

100 W*, min. RMS, driven into 8 Ω at 1 kHz, with

 

no more than 0.8% total harmonic distortion.

Surround ch: 100 W* per channel, min. RMS, driven into 8 Ω at

 

1 kHz, with no more than 0.8% total harmonic

 

distortion.

 

Surround Back ch:

 

 

100 W*, min. RMS, driven into 8 Ω at 1 kHz, with

 

no more than 0.8% total harmonic distortion.

 

(* Measured on AC 110 V, 127 V, 220 V and 240 V)

Audio

 

 

Audio Input Sensitivity/Impedance (1 kHz)

200 mV/47 kΩ

DVD IN, VCR IN, TV SOUND/DBS IN:

CD IN, TAPE/CDR IN:

200 mV/47 kΩ

Audio Input (DIGITAL IN)*

0.5 V(p-p)/75 Ω

Coaxial:DIGITAL 1 (DVD):

Optical:DIGITAL 2 (CD), DIGITAL 3 (TV), DIGITAL 4 (CDR):

–21 dBm to –15 dBm (660 nm ±30 nm)

*Corresponding to Linear PCM, Dolby Digital, and DTS Digital Surround (with sampling frequency — 32 kHz, 44.1 kHz, 48 kHz).

Audio Output Level:

SUBWOOFER OUT:

1 V

Recording Output Level:

VCR OUT, TAPE/CDR OUT: 200 mV

Digital output:

Optical: DIGITAL OUT

 

 

 

Signal wave length:

660 nm

 

 

Output level: –21 dBm to –15 dBm

Signal-to-Noise Ratio (’66 IHF/DIN)

 

DVD IN, VCR IN, TV SOUND/DBS IN:

87 dB/67 dB

CD IN, TAPE/CDR IN:

 

87 dB/67 dB

Frequency Response (8 Ω)

 

 

DVD IN, VCR IN, TV SOUND/DBS IN:

 

 

 

20 Hz to 100 kHz (+1 dB, –3 dB)

CD IN, TAPE/CDR IN:

20 Hz to 100 kHz (+1 dB, –3 dB)

Equalization (5 bands):

 

 

 

63 Hz, 250 Hz, 1 kHz, 4 kHz, 16 kHz (±8 dB)

Bass boost:

 

+6 dB ±1.0 dB at 100 Hz

Video

Video Input Sensitivity/Impedance

Composite video: DVD IN, VCR IN, TV SOUND/DBS IN:

1 V(p-p)/75 Ω

S-video: DVD IN, VCR IN, TV SOUND/DBS IN:

(Y: luminance):

1 V(p-p)/75 Ω

(C: chrominance, burst):

0.286 V(p-p)/75 Ω

Component video: DVD IN, DBS IN:

 

(Y: luminance):

1 V(p-p)/75 Ω

(PB/PR):

0.7 V(p-p)/75 Ω

Video Output Level

 

Composite video: VCR OUT, MONITOR OUT: 1 V(p-p)/75 Ω

S-video: VCR OUT, MONITOR OUT:

 

(Y: luminance):

1 V(p-p)/75 Ω

 

(C: chrominance, burst): 0.286 V(p-p)/75 Ω

Component video: MONITOR OUT

1 V(p-p)/75 Ω

 

(Y: luminance):

 

(PB/PR):

0.7 V(p-p)/75 Ω

Synchronization:

 

Negative

Signal-to-Noise Ratio:

45 dB

FM tuner (IHF)

 

 

Tuning Range:

 

87.50 MHz to 108.00 MHz

Usable Sensitivity:

Monaural:

12.8 dBf (1.2 µV/75 Ω)

50 dB Quieting Sensitivity: Monaural:

16.0 dBf (1.7 µV/75 Ω)

 

Stereo:

37.5 dBf (20.5 µV/75 Ω)

Stereo Separation at REC OUT:

35 dB at 1 kHz

AM tuner

 

 

Tuning Range:

531 kHz to 1 602 kHz (at 9 kHz intervals)

 

530 kHz to 1 600 kHz (at 10 kHz intervals)

General

 

 

Power Requirements:

AC 110 V/127 V/220 V/230 V – 240 V ,

adjustable with the voltage selector, 50 Hz/60 Hz

Power Consumption:

 

250 W (at operation)

 

 

4.5 W (in standby mode)

Dimensions (W x H x D):

435 mm x 157 mm x 425 mm

Mass:

 

12.2 kg

Designs & specifications are subject to change without notice.

English

50

Page 52 Page 54
Image 53
Page 52 Page 54
Contents RX-7032VSL Precaução -- Interruptor STANDBY/ON Precaución -- Interruptor STANDBY/ONPrecaución Ventilación Adecuada Introduction FeaturesPrecautions Table of Contents Buttons 15, 44 Remote ControlParts Identification Inside the front door Front PanelDisplay Window Press down on PUSH-OPEN How to open the front doorOutput Rear PanelChecking the Supplied Accessories Before InstallationAdjusting the Voltage Selector Putting Batteries in the Remote ControlAM Antenna Connections Connecting the FM and AM AntennasFM Antenna Connections Outdoor FM Antenna CableInsert the speaker signal cable Connecting the SpeakersBasic connecting procedure Close the speaker terminalPlacing speakers Connecting the subwoofer speakerFront speakers and center speaker Surround and surround back speakersAnalog Connections Connecting Audio/Video ComponentsCassette deck CD playerIf your video components have an AV Compulink jack Video component connectionsTV and/or DBS tuner To listen to the sound after connection, press VCRTo listen to the sound after connection, press DVD Multi DVD playerDVD player Plug the power cord into an AC outlet Connecting the Power CordDigital Connections Digital output terminalBasic Operations Daily Operational Procedure Selecting the Source to PlayTurning On the Power Speaker and signal indicators on the display Adjusting the VolumeWhen analog input is selected Always lights up Selecting different sources for picture and soundListening with headphones only Selecting the Analog or Digital Input ModeSubwoofer Sound To use the speakers connected to the Front SpeakersTo select the analog input mode again Setting the Dynamic RangeTurning Analog Direct On and Off Reinforcing the Bass Using the Sleep TimerMuting the Sound Changing the Display BrightnessReceiving Radio Broadcasts Tuning in to Stations ManuallyUsing Preset Tuning While listening to an FM station, press FM Mode Selecting the FM Reception ModePress the 10 keys to select a preset channel number To tune in a preset stationSetting the Speakers Configuration Remote Basic SettingsPress Quick Speaker Setup Press in Multi JOG Push SETSpeakers channels number and size Basic Setting ItemsRoom size and speaker distance Items To do SeePress Setting Basic ProcedureSetting the Speakers Push in Multi JOG Push SETSurround back speakers quantity-SBACK OUT Setting the Speaker Distance2SPK Select this to use 2 surround back speakers Measuring unit-DIST UnitSelecting main or sub channel-DUAL Mono Setting the Bass SoundsSelect one of the following Select the playback sounds channelSetting the Component Video Input Setting the Digital Input TerminalsMemorizing the Volume Level for Each Source To recall the volume levelBasic Setting Items Basic Procedure Adjusting SoundPress Adjust Ex. When adjusting the subwoofer level toAdjusting the Speaker Output Levels Adjusting the Equalization PatternsEqualization adjustment-DIGITAL EQ Repeat steps 2 and 3 to adjust the other center frequencyAdjustable parameters Select a speaker you want to adjustFor DAP modes For Pro Logic II Music onlyReproducing Theater Ambience Introducing the Surround Modes Using the Surround ModesDTS Digital Surround What is Dual Mono?DTS Extended Surround DTS-ES DTS 96/24EX/ES Setting Available Surround Mode Incoming Signal TypeSurround Modes Applicable to the Various Software 3D Headphone Mode-3D H PhoneSelect and play any source other than DVD Multi Press Surround to activate the Surround modeActivating the Surround Modes 3D Headphone Mode Using the DSP ModesReproducing the Sound Field Introducing the DSP ModesALL Channel Stereo mode To cancel the DSP modesMulti-channel digital signals Activating the DSP ModesActivating the DVD Multi Playback Mode Using the DVD Multi Playback ModeConnection diagram Press DVD Multi so that DVD Multi appears on the displayRemote Control through the Remote Sensor on the Receiver Compu Link Remote Control SystemPress the play 3 button on the CD player Automatic Source SelectionConnections 1 AV Compu Link Connection AV Compu Link Remote Control SystemConnections 2 Video Cable Connection Video cord To Video InputAutomatic Power On/Off Automatic Selection of TV’s Input ModeOne-Touch Video Play One-Touch DVD PlayOperating Audio Components Operating JVC’s Audio/Video ComponentsTuner Sound control section Amplifier7/P CD changerCD recorder Cassette deckCH + Operating Video ComponentsDVD player Release TV If there are more than one code listed for your brand of TVTry to operate your TV by pressing TV For TV Manufacturer CodesFor DBS tuner Release CATV/DBSFor Catv converter Manufacturer CodesRelease VCR If there are more than one code listed for your brandTry to operate your VCR by pressing VCR For VCRFor DVD player Release AudioDenon Panasonic Philips Pioneer 04, 05 Samsung Sony Toshiba YamahaProblem Possible Cause Solution TroubleshootingVideo SpecificationsAudio Precaução para a ligação à tensão da rede CA Precaución para la línea de la red CA
Top Page Image Contents