English
Selecting the Front Speakers | Remote |
| NOT |
Activating and Adjusting the | Remote |
When you have connected two pairs of the front speakers, you can
Subwoofer Sound
NOT
select which to use.
You can cancel the subwoofer sound even though you have connected a subwoofer and have set “SUB WOOFER” to “YES” (see page 25). This is useful when enjoying surround sound at night.
To use the speakers connected to the FRONT SPEAKERS 1
terminals, press SPEAKERS ON/OFF 1 so that the SPEAKERS 1 indicator lights up on the display. Make sure that the SPEAKERS 2 indicator is not lit on the display.
To use the speakers connected to the FRONT SPEAKERS 2
terminals, press SPEAKERS ON/OFF 2 so that SPEAKERS 2 indicator lights up on the display. Make sure that the SPEAKERS 1 indicator is not lit on the display.
To use both sets of the speakers, press SPEAKERS ON/OFF 1 and SPEAKERS ON/OFF 2 so that the SPEAKERS 1/2 indicators light up on the display.
To use neither sets of the speakers, press SPEAKERS ON/OFF 1 and SPEAKERS ON/OFF 2 so that the SPEAKERS 1/2 indicators go off from the display.
The HEADPHONE indicator lights up and “HEADPHONE” appears on the display.
•Activating the speakers turns on the Surround and DSP modes previously selected.
Listening with headphones only:
Deactivate both sets of the front speakers, and connect headphones to the PHONES jack.
You can enjoy the sound effects through the headphones when Surround or DSP mode is
•“3D H PHONE” appears on the display and the DSP and HEADPHONE indicator lights up on the display. (For details, see page 36.)
Note:
When you select “DVD MULTI” as the source or any one of the Surround/DSP mode which activates the center and/or surround speaker(s), you can use only one set of the speakers.
CAUTION:
Be sure to turn down the volume:
•Before connecting or putting on headphones, as its high volume can damage both the headphones and your hearing.
•Before turning on speakers again, as its high volume may come out of the speakers.
Press SUBWOOFER OUT ON/OFF to cancel the subwoofer sound output.
Each time you press the button, subwoofer sound output is deactivated (“SUBWFR OFF”) and activated (“SUBWFR ON”) alternately.
•When subwoofer sound output is activated, subwoofer output level can be adjusted using the remote control.
1 Press SOUND.
2 Press SUBWOOFER.
3 Press LEVEL + or – to adjust the output level
Note:
You cannot deactivate the subwoofer sound output when you set
“SMALL” for the front speakers on the speaker size setting (see page 25) or Quick Speaker Setup (see page 23).
Selecting the Analog or Digital Input Mode
When you have connected digital source components using the digital terminals (see page 14), change the input mode for these components to the digital input mode.
1
2
Before you start, remember...
The digital input terminal setting should be correctly done for the sources you want to select the digital input mode (see “Setting the Digital Input Terminals” on page 28).
1.Press one of the source selection buttons for which you want to change the input mode.
DVD, TV (SOUND)/DBS, CD, or TAPE/CDR*
DVD MULTI | DVD | VCR | TV SOUND/DBS | CD | TAPE/CDR | FM | AM |
|
|
|
|
|
|
|
|
On the unit
DVD CD
TV/DBSTAPE/CDR
On the remote
*If “TAPE” has been assigned as the source name, digital input mode is not available. To change the source name, see “Changing the Source Name” on page 19.
17