JVC RX-6012VSL manual English, Press SETTING repeatedly until

Page 16
Manual background

English

Crossover Frequency Setting

Small speakers cannot reproduce the bass sound very well. So, if you have used a small speaker for any of the front, center, and rear channels, this receiver automatically reallocates the bass elements, originally assigned to the channel for which you have connected the small speaker, to another channel (for which you have connected the large speaker).

If you have selected “LARGE” for all speakers (see page 12), this function will not take effect. To use this function properly, you need to set this crossover frequency level according to the size of the small speaker connected.

On the front panel ONLY:

1. Press SETTING repeatedly until

T SETTING

 

“CROSSOVER FRQ” (Crossover

 

 

 

 

 

 

Frequency) appears on the display.

The display changes to show the current setting.

2. Press CONTROL UP 5/DOWN ° CONTROL

DOWN UP

to select the crossover frequency level according to the size of the small speaker connected.

Each time you press the button, the display changes to show the following:

Low Frequency Effect Attenuator Setting

If the bass sound is distorted while playing back a source using Dolby Digital or DTS Digital Surround, follow the procedure below.

On the front panel ONLY:

1. Press SETTING repeatedly until

ST SETTING

 

“LFE ATT” (Low Frequency

 

 

 

 

 

 

Effect Attenuator) appears on the display.

The display changes to show the current setting.

2. Press CONTROL UP 5/DOWN ° CONTROL

DOWN UP

to select the low frequency effect attenuator level.

Each time you press the button, the display changes to show the following:

0dB Manual backgroundManual background 10dB

0dB: Normally select this.

10dB: Select this when the bass sound is distorted.

Note:

This function takes effect only when the subwoofer (LFE) signals come in, (with “SUBWOOFER” set to “YES.”)

Manual backgroundManual background 80HZ Manual backgroundManual background100HZ Manual backgroundManual background120HZ Manual backgroundManual background

• Use the following comments as reference when adjusting.

80HZ: Select this when the cone speaker unit built in the speaker is about 12 cm.

100HZ: Select this when the cone speaker unit built in the speaker is about 10 cm.

120HZ: Select this when the cone speaker unit built in the speaker is about 8 cm.

Note:

Crossover frequency is not valid for the HEADPHONE mode.

Dynamic Range Compression Setting

You can compress the dynamic range (difference between maximum sound and minimum sound) of the reproduced sound. This is useful when enjoying surround sound at night.

This function takes effect only when playing back a source using Dolby Digital.

On the front panel ONLY:

1. Press SETTING repeatedly until

T SETTING

 

“D_RANGE COMP” (Dynamic

 

 

 

 

 

 

Range Compression) appears on the display.

The display changes to show the current setting.

2. Press CONTROL UP 5/DOWN ° CONTROL

DOWN UP

to select the appropriate item about the compression level.

Each time you press the button, the display changes to show the following:

Manual backgroundOFF Manual backgroundManual background MIDManual backgroundManual background MAXManual background

OFF: Select this when you want to enjoy surround with its full dynamic range. (No effect applied.)

MID: Select this when you want to reduce the dynamic range a little. (Factory setting.)

MAX: Select this when you want to apply the compression effect fully. (Useful at night.)

Note:

Dynamic Range Compression is not valid for the DTS Digital Surround.

13

Image 16
Contents MASTER VOLUME VOLUMERX-6010VBK / RX-6012VSL AUDIO/VIDEO CONTROL RECEIVERCaution --switch Precaución --InterruptorPrecaução --Interruptor PRECAUCIÓNEnglish Español Português Caution Proper VentilationPrecaución Ventilación Adecuada Precaução ventilação apropriadaTable of Contents Basic SettingsUsing the DSP Modes COMPU LINK Remote Control SystemParts Identification Remote ControlEnglish q w e r t yGetting Started Before InstallationChecking the Supplied Accessories Connecting the FM and AM AntennasConnecting the Speakers Basic connecting procedureConnecting the front speakers Connecting the rear and center speakersConnecting Audio/Video Components Connecting the subwoofer speakerPowered subwoofer EnglishEnglish Video component connectionsDVD player To audioConnecting the Power Cord Putting Batteries in the Remote ControlPlug the power cord into an AC outlet EnglishBasic Operations Turning the Power On and Off StandbyTo turn on the power, press To turn off the power into standby modeListening Only with Headphones Adjusting the VolumeFrom the remote control To increase the volume, turn MASTERAdjusting the Subwoofer Output Level Adjusting the ToneAttenuating the Input Signal EnglishBasic Settings Setting the Subwoofer InformationAdjusting the Front Speaker Output Balance English1. Press SETTING repeatedly until Setting the Speakers for the DSP ModesEnglish 1. Press SETTING repeatedly until EnglishDigital Input DIGITAL IN Terminal Setting 1. Press SETTING repeatedly untilEnglish Selecting the Analog or Digital Input ModeStoring the Basic Settings and Adjustments Using the Sleep TimerFrom the remote control ONLY From the remote controlReceiving Radio Broadcasts Setting the AM Tuner Interval SpacingTuning in Stations Manually Using Preset TuningTo tune in a preset station From the remote controlEnglish Selecting the FM Reception ModeUsing the DSP Modes EnglishWhat are the DSP Modes? Surround modesEnglish Reproducing the Sound FieldDAP modes Available DSP modes according to the input modeEnglish Available DSP modesBy pressing DSP MODE By pressing SURROUND MODE5.Adjust the speaker output levels Adjusting the Surround ModesEnglish JVC Theater Surround adjustments From the remote controlThe PRO LOGIC and DSP indicators also EnglishEnglish Adjusting the DAP Modeson the display To cancel the Dolby/DTS Surround mode To cancel the DSP modeTo cancel the DSP mode To cancel the Dolby/DTS Surround modeCOMPU LINK Remote Control System EnglishAutomatic Source Selection Synchronized RecordingOperating JVC’s Audio/Video Components EnglishOperating Audio Components TunerEnglish Operating Video ComponentsCD changer Cassette deckTroubleshooting PROBLEMSOLUTION EnglishSpecifications EnglishAmplifier AudioEnglish FM tuner IHFAM tuner GeneralCAUTION for mains AC line PRECAUCIÓN para la línea de la red CAPRECAUÇÃO para a ligação à tensão da rede CA EN, SP, PR, CH