JVC RX-6012VSL manual English, FM tuner IHF, AM tuner, General

Page 33
FM tuner (IHF)

FM tuner (IHF)

Tuning Range:

Usable Sensitivity:

50 dB Quieting Sensitivity:

Signal-to-Noise Ratio (IHF-A weighted):

Total Harmonic Distortion:

Stereo Separation at REC OUT:

Alternate Channel Selectivity:

Frequency Response:

AM tuner

Tuning Range:

Usable Sensitivity:

Signal-to-Noise Ratio:

General

Power Requirements:

Power Consumption:

Dimensions (W x H x D):

Mass:

87.50 MHz to 108.00 MHz

 

Monaural:

12.8 dBf (1.95 µV/75

Ω)

Monaural:

21.3 dBf (3.2 µV/75

Ω)

Stereo:

41.3 dBf (31.5 µV/75

Ω)

Monaural:

78 dB at 85 dBf

 

Stereo:

73 dB at 85 dBf

 

Monaural:

0.4% at 1 kHz

 

Stereo:

0.6% at 1 kHz

 

35 dB at 1 kHz

45 dB: (±400 kHz)

30 Hz to 15 kHz: (+0.5 dB, –3 dB)

531 kHz to 1 602 kHz (at 9 kHz intervals) 530 kHz to 1 600 kHz (at 10 kHz intervals)

Loop antenna

400 µV/m

 

50 dB (100 mV/m)

AC 110 V/127 V/220 V/230 V – 240 V , adjustable with the voltage selector, 50 Hz/60 Hz

200 W (at operation)

5 W (in standby mode)

435 mm x 146.5 mm x 416 mm (17 3/16 in. x 5 13/16 in. x 16 7/16 in.)

9.6 kg (21.2 lbs)

Designs & specifications are subject to change without notice.

English

30

Image 33
Contents VOLUME MASTER VOLUMERX-6010VBK / RX-6012VSL AUDIO/VIDEO CONTROL RECEIVERPrecaución --Interruptor Caution --switchPrecaução --Interruptor PRECAUCIÓNCaution Proper Ventilation English Español PortuguêsPrecaución Ventilación Adecuada Precaução ventilação apropriadaBasic Settings Table of ContentsUsing the DSP Modes COMPU LINK Remote Control SystemRemote Control Parts IdentificationEnglish q w e r t yBefore Installation Getting StartedChecking the Supplied Accessories Connecting the FM and AM AntennasBasic connecting procedure Connecting the SpeakersConnecting the front speakers Connecting the rear and center speakersConnecting the subwoofer speaker Connecting Audio/Video ComponentsPowered subwoofer EnglishVideo component connections EnglishDVD player To audioPutting Batteries in the Remote Control Connecting the Power CordPlug the power cord into an AC outlet EnglishTurning the Power On and Off Standby Basic OperationsTo turn on the power, press To turn off the power into standby modeAdjusting the Volume Listening Only with HeadphonesFrom the remote control To increase the volume, turn MASTERAdjusting the Tone Adjusting the Subwoofer Output LevelAttenuating the Input Signal EnglishSetting the Subwoofer Information Basic SettingsAdjusting the Front Speaker Output Balance EnglishSetting the Speakers for the DSP Modes 1. Press SETTING repeatedly untilEnglish English 1. Press SETTING repeatedly until1. Press SETTING repeatedly until Digital Input DIGITAL IN Terminal SettingEnglish Selecting the Analog or Digital Input ModeUsing the Sleep Timer Storing the Basic Settings and AdjustmentsFrom the remote control ONLY From the remote controlSetting the AM Tuner Interval Spacing Receiving Radio BroadcastsTuning in Stations Manually Using Preset TuningFrom the remote control To tune in a preset stationEnglish Selecting the FM Reception ModeEnglish Using the DSP ModesWhat are the DSP Modes? Surround modesReproducing the Sound Field EnglishDAP modes Available DSP modes according to the input modeAvailable DSP modes EnglishBy pressing DSP MODE By pressing SURROUND MODEAdjusting the Surround Modes 5.Adjust the speaker output levelsEnglish From the remote control JVC Theater Surround adjustmentsThe PRO LOGIC and DSP indicators also EnglishAdjusting the DAP Modes Englishon the display To cancel the DSP mode To cancel the Dolby/DTS Surround modeTo cancel the DSP mode To cancel the Dolby/DTS Surround modeEnglish COMPU LINK Remote Control SystemAutomatic Source Selection Synchronized RecordingEnglish Operating JVC’s Audio/Video ComponentsOperating Audio Components TunerOperating Video Components EnglishCD changer Cassette deckPROBLEM TroubleshootingSOLUTION EnglishEnglish SpecificationsAmplifier AudioFM tuner IHF EnglishAM tuner GeneralPRECAUCIÓN para la línea de la red CA CAUTION for mains AC linePRECAUÇÃO para a ligação à tensão da rede CA EN, SP, PR, CH