JVC RX-6012VSL English, Connecting the Speakers, AM Antenna Connections, AM loop, Center speaker

Page 7
AM Antenna Connections

AM Antenna Connections

 

 

 

 

Snap the tabs on the loop into the

ANTENNA

 

slots of the base to assemble the

 

 

FM 75

 

 

AM loop.

 

 

COAXIAL

 

 

 

 

 

 

 

 

 

 

Basic connecting procedure

1

2

3

 

 

 

English

AM

LOOP

1

AM Loop Antenna

AM

EXT

23

1Cut, twist and remove the insulation at the end of each speaker signal cable (not supplied).

2Open the terminal and then insert the speaker signal cable.

3Close the terminal.

Connecting the front speakers

Connect front speakers to the FRONT SPEAKERS terminals.

Outdoor single vinyl-covered wire (not supplied)

Turn the loop until you have the best reception.

Left speaker

Right speaker

Notes:

• If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram.

• Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This could cause poor reception.

If reception is poor, connect an outdoor single vinyl-covered wire to the AM EXT terminal. (Keep the AM loop antenna connected.)

FRONT

SPEAKERS

RIGHT

LEFT

Connecting the Speakers

You can connect the following speakers:

One pair of front speakers to produce normal stereo sound.

One pair of rear speakers to enjoy the surround effect.

One center speaker to produce more effective surround effect (to emphasize human voices).

One subwoofer to enhance the bass.

IMPORTANT:

After connecting the speakers listed above, set the speaker setting information properly to obtain the best possible DSP effect. For details, see page 12.

For each speaker (except for a subwoofer), connect the (+) and (–) terminals on the rear panel to the (+) and (–) terminals marked on the speakers. For connecting a subwoofer, see page 5.

CAUTION:

Use speakers with the SPEAKER IMPEDANCE indicated by the speaker terminals.

Connecting the rear and center speakers

Connect rear speakers to the REAR SPEAKERS terminals and a center speaker to the CENTER SPEAKER terminals.

 

CENTER

REAR

 

SPEAKER

SPEAKERS

Center speaker

RIGHT

LEFT

 

 

Left rear

Right rear

 

 

speaker

speaker

 

 

4

Image 7
Contents AUDIO/VIDEO CONTROL RECEIVER MASTER VOLUMEVOLUME RX-6010VBK / RX-6012VSLPRECAUCIÓN Caution --switchPrecaución --Interruptor Precaução --InterruptorPrecaução ventilação apropriada English Español PortuguêsCaution Proper Ventilation Precaución Ventilación AdecuadaCOMPU LINK Remote Control System Table of ContentsBasic Settings Using the DSP Modesq w e r t y Parts IdentificationRemote Control EnglishConnecting the FM and AM Antennas Getting StartedBefore Installation Checking the Supplied AccessoriesConnecting the rear and center speakers Connecting the SpeakersBasic connecting procedure Connecting the front speakersEnglish Connecting Audio/Video ComponentsConnecting the subwoofer speaker Powered subwooferTo audio EnglishVideo component connections DVD playerEnglish Connecting the Power CordPutting Batteries in the Remote Control Plug the power cord into an AC outletTo turn off the power into standby mode Basic OperationsTurning the Power On and Off Standby To turn on the power, pressTo increase the volume, turn MASTER Listening Only with HeadphonesAdjusting the Volume From the remote controlEnglish Adjusting the Subwoofer Output LevelAdjusting the Tone Attenuating the Input SignalEnglish Basic SettingsSetting the Subwoofer Information Adjusting the Front Speaker Output Balance1. Press SETTING repeatedly until Setting the Speakers for the DSP ModesEnglish English 1. Press SETTING repeatedly untilSelecting the Analog or Digital Input Mode Digital Input DIGITAL IN Terminal Setting1. Press SETTING repeatedly until EnglishFrom the remote control Storing the Basic Settings and AdjustmentsUsing the Sleep Timer From the remote control ONLYUsing Preset Tuning Receiving Radio BroadcastsSetting the AM Tuner Interval Spacing Tuning in Stations ManuallySelecting the FM Reception Mode To tune in a preset stationFrom the remote control EnglishSurround modes Using the DSP ModesEnglish What are the DSP Modes?Available DSP modes according to the input mode EnglishReproducing the Sound Field DAP modesBy pressing SURROUND MODE EnglishAvailable DSP modes By pressing DSP MODE5.Adjust the speaker output levels Adjusting the Surround ModesEnglish English JVC Theater Surround adjustmentsFrom the remote control The PRO LOGIC and DSP indicators alsoEnglish Adjusting the DAP Modeson the display To cancel the Dolby/DTS Surround mode To cancel the Dolby/DTS Surround modeTo cancel the DSP mode To cancel the DSP modeSynchronized Recording COMPU LINK Remote Control SystemEnglish Automatic Source SelectionTuner Operating JVC’s Audio/Video ComponentsEnglish Operating Audio ComponentsCassette deck EnglishOperating Video Components CD changerEnglish TroubleshootingPROBLEM SOLUTIONAudio SpecificationsEnglish AmplifierGeneral EnglishFM tuner IHF AM tunerEN, SP, PR, CH CAUTION for mains AC linePRECAUCIÓN para la línea de la red CA PRECAUÇÃO para a ligação à tensão da rede CA