English
Getting Started
This section explains how to connect audio/video components and speakers to the receiver, and how to connect the power supply.
Before Installation
General
•Be sure your hands are dry.
•Turn the power off to all components.
•Read the manuals supplied with the components you are going to connect.
Locations
•Install the receiver in a location that is level and protected from moisture.
•The temperature around the receiver must be between
•Make sure there is good ventilation around the receiver. Poor ventilation could cause overheating and damage the receiver.
Handling the receiver
•Do not insert any metal object into the receiver.
•Do not disassemble the receiver or remove screws, covers, or cabinet.
•Do not expose the receiver to rain or moisture.
Checking the Supplied Accessories
Check to be sure you have all of the following items, which are supplied with the receiver.
The number in the parentheses indicates the quantity of the pieces supplied.
•Remote Control (1)•Batteries (2)
•AM Loop Antenna (1)
•FM Antenna (1)•AC Plug Adaptor (1)
If anything is missing, contact your dealer immediately.
Connecting the FM and AM Antennas
FM Antenna Connections
A |
| AN | TENNA | M | 75L |
| B |
| ANTENNA | M | 75L |
| ||||
|
|
| F |
| AXIA |
|
|
|
| F |
| AXIA |
|
| ||
|
|
| CO |
|
|
|
|
|
| CO |
|
|
|
| ||
| A | M |
|
|
| A | M |
| A | M |
|
| A | M | ||
| OP |
|
|
| EX | T |
| OP |
|
| EX | T | ||||
| LO |
|
|
|
|
| LO |
|
|
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
FM Antenna
ANTENNA Extend the supplied FM antenna horizontally.
FM 75
COAXIAL
AM | Outdoor FM Antenna Cable |
LOOP |
|
AM
EXT
A.Using the Supplied FM AntennaThe FM antenna provided can be connected to the FM 75 Ω COAXIAL terminal as temporary measure.
B.Using the Standard Type Connector (Not Supplied)A standard type connector should be connected to the FM 75 Ω COAXIAL terminal.
Note:
If reception is poor, connect an outdoor antenna.
Before attaching a 75 Ω coaxial cable (the kind with a round wire going to an outdoor antenna), disconnect the supplied FM antenna.
Setting the Voltage Selector Switch
Before connections, always do the following first if necessary.
Set the correct voltage for your area with the voltage selector switch on the rear panel. Rotate the voltage selector using a screw driver, so the voltage number the voltage mark is set at is the same as the voltage where you are plugging in the receiver.
VOLTAGE SELECTOR
220V
110V
127V
230 - 240V
Voltage mark
3