When playing a software encoded with the DTS Digital
Surround, “AUTO” may not work properly and the following symptoms may occur:
•Sound does not come out at the beginning of playback.
•Noise comes out while using the searching or skipping function.
In this case, press CONTROL UP 5/ | CONTROL |
DOWN °to select “DTS” while “AUTO” | DOWN UP |
|
is lit on the display.
•Each time you press the button, the input mode changes as follows:
AUTO 
DTS
(Digital) (Digital)
The DIGITAL AUTO indicator does not light up on the display while “DTS” is selected.
To change the input mode back to “AUTO,” press CONTROL UP 5/DOWN °while “DTS” is lit on the display after pressing
INPUT DIGITAL.
If 
flashes while “DTS” is selected as the input mode, select “AUTO.”
Note:
When you turn off the power or select another source, “DTS” setting is canceled and the digital input mode is automatically reset to “AUTO.”
Storing the Basic Settings and
Adjustments
You can assign and store different sound settings for each different playing source. By using this function, you do not have to change the settings every time you change the source. The stored settings for the newly selected source are automatically recalled.
The following can be stored for each source:
•Subwoofer output level (see page 10)
•Input attenuator mode (see page 10)
•Tone adjustment (see page 10)
•Balance (see page 11)
•DSP modes
–Surround mode (see page 24)
–DAP mode (see page 26)
The above settings are stored automatically in the following cases:
•When you turn on the power.
•When you change the source.
•When you assign the source name.
Notes:
•You cannot assign and store different settings for digital input mode and analog input mode.
•If the source is FM or AM (MW/LW), you can assign a different setting for each band.
To change the input mode back to analog |
|
input, press INPUT ANALOG. | INPUT ANALOG |
“ANALOG” appears on the display for a |
|
while. | INPUT ATT |
|
Using the Sleep Timer
Using the Sleep Timer, you can fall asleep to music and know the receiver will turn off by itself rather than play all night.
From the remote control ONLY:
From the remote control:
1.Press the source selecting button (DVD, TV SOUND, CD, or TAPE/CDR)* for which you want to change the input mode.
Note:
DVD | TV SOUND |
CD TAPE/CDR
Press SLEEP repeatedly. | SLEEP |
|
The SLEEP indicator lights up on the display, and the
(in minutes):
10 
20 
30 
40 
50 
60 
70 
80 
90
00(Canceled) 
*Among the sources listed above, you can select the digital input only for the sources which you have selected the digital input terminals for. (See “Digital Input (DIGITAL IN) Terminal Setting.”)
2. Press ANALOG/DIGITAL to | ANALOG/DIGITAL |
| |
change the input mode. |
|
•Each time you press the button, the input mode changes as follows:
ANALOG 
AUTO
(Digital)
When playing a software encoded with the DTS Digital
Surround, “AUTO” may not work properly. In this case, press CONTROL UP 5/DOWN °on the front panel to select “DTS.” (See above.)
Note:
You can only select “ANALOG” and “AUTO” using the remote control.
When the
The receiver turns off automatically.
To check or change the time remaining until the
Press SLEEP once.
The remaining time until the
• To change the
To cancel the Sleep Timer
Press SLEEP repeatedly until “SLEEP 00 MIN.” appears on the display. (The SLEEP indicator goes off.)
• Turning off the power also cancels the Sleep Timer.
15