JVC RX-6010RBK, RX-6012RSL manual If in Doubt Consult a Competent Electrician

Page 2

Warnings, Cautions and Others

IMPORTANT for the U.K.

DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer.

BE SURE to replace the fuse only with an identical approved type, as originally fitted.

If nonetheless the mains plug is cut off ensure to remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the mains supply.

If this product is not supplied fitted with a mains plug then follow the instructions given below:

IMPORTANT.

DO NOT make any connection to the terminal which is marked with the letter E or by the safety earth symbol or coloured green or green-and-yellow.

The wires in the mains lead on this product are coloured in accordance with the following code:

Blue : Neutral

Brown : Live

As these colours may not correspond with the coloured markings identifying the terminals in your plug proceed as follows:

The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.

The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.

IF IN DOUBT - CONSULT A COMPETENT ELECTRICIAN.

CAUTION

To reduce the risk of electrical shocks, fire, etc.:

1.Do not remove screws, covers or cabinet.

2.Do not expose this appliance to rain or moisture.

Caution –– switch!

Disconnect the mains plug to shut the power off completely.

The switch in any position does not disconnect the mains line. The power can be remote controlled.

CAUTION

Do not block the ventilation openings or holes.

(If the ventilation openings or holes are blocked by a newspaper or cloth, etc., the heat may not be able to get out.)

Do not place any naked flame sources, such as lighted candles, on the apparatus.

When discarding batteries, environmental problems must be considered and local rules or laws governing the disposal of these batteries must be followed strictly.

Do not use this apparatus in a bathroom or places with water. Also do not place any containers filled with water or liquids (such as cosmetics or medicines, flower vases, potted plants, cups, etc.) on top of this apparatus.

G-1

Image 2
Contents RX-6010RBK / RX-6012RSL If in Doubt Consult a Competent Electrician RX-6010RBK RX-6012RSL Table of Contents W e r t Remote Control Front PanelParts Identification Connecting the FM and AM MW/LW Antennas Before InstallationChecking the Supplied Accessories Getting StartedConnecting the front speakers Connecting the SpeakersBasic connecting procedure Connecting the rear and center speakersAnalog connections Connecting Audio/Video ComponentsConnecting the subwoofer speaker Audio component connectionsOutput Video component connectionsDVD player To video inputPlug the power cord into an AC outlet Connecting the Power CordPutting Batteries in the Remote Control Digital connectionsSignal and speaker indicators on the display Turning the Power On and Off StandbyFrom the remote control Basic OperationsMuting the Sound Listening Only with HeadphonesThrough all speakers and headphones Connected Press Muting to mute the soundAttenuating the Input Signal Adjusting the Subwoofer Output LevelAdjusting the Tone Adjusting the Front Speaker Output Balance Basic SettingsRecording a Source Setting the Subwoofer Information Changing the Source NameSetting the Speakers for the DSP Modes To select the low frequency effect Attenuator level Crossover FRQ Crossover Frequency appears on the displayLFE ATT Low Frequency Effect Attenuator appears on Display Digital Input Digital in Terminal Setting Selecting the Analog or Digital Input ModeChange the input mode Storing the Basic Settings AdjustmentsUsing the Sleep Timer Press Sleep repeatedlyReceiving Radio Broadcasts Tuning in Stations ManuallyUsing Preset Tuning Selecting the FM Reception Mode Using the RDS Radio Data System to Receive FM Stations Searching for a Program by PTY CodesProgram type appears on the display Switching to a Broadcast Program of Your Choice TemporarilyPress EON so that the last selected Press TA/NEWS/INFO untilTo stop listening to the program selected by EON You have selectedIf the FM station you are listening to is Surround modes Using the DSP ModesWhat are the DSP Modes? Early reflections Behind Direct sounds Reproducing the Sound FieldDAP modes Possible × ImpossibleAvailable DSP Modes According to the Speaker Arrangement FrontAdjusting the Surround Modes Level you want Adjust the effect levelJVC Theater Surround adjustments Press Test again to stop the test toneAdjust the rear speaker output levels Press Sound Adjusting the DAP ModesPress DSP Mode repeatedly until Adjust the rear speaker outputActivating the DSP Modes Mode you want appears on DisplayPress Surround Mode Press Surround ON/OFFPress the play 3 button on the CD player Compu Link Remote Control SystemRemote Control through the Remote Sensor on the Receiver Automatic Source SelectionTuner Operating JVC’s Audio/Video ComponentsOperating Audio Components Sound control section AmplifierCassette deck Operating Video ComponentsCD changer CD recorderTroubleshooting Problem Possible Cause SolutionFM tuner IHF SpecificationsAmplifier AM MW/LW tuner0301NHMMDWJEIN