CASE 1 | If there is no station broadcasting the program | |
you have selected | ||
|
The receiver continues playing the current source (all sources except AM — MW/LW).
Ô
When a station starts broadcasting the program you have selected, the receiver automatically switches to the station. The indicator of received PTY code starts flashing.
Ô
When the program is over, the receiver goes back to the previously selected source, but still remains in EON standby mode. The indicator of received PTY code stops flashing and remains lit.
CASE 2 | If there is a station broadcasting the program | |
you have selected | ||
|
The receiver changes the source (all sources except AM — MW/LW), and tunes in the station. The indicator of received PTY code starts flashing.
Ô
When the program is over, the receiver goes back to the previously selected source, but still remains in EON standby mode. The indicator of received PTY code stops flashing and remains lit.
CASE 3 | If the FM station you are listening to is | |
broadcasting the program you have selected | ||
|
The receiver continues to receive the station, but the indicator of received PTY code starts flashing.
Ô
When the program is over, the indicator of received PTY code stops flashing and remains lit, but the receiver remains in EON standby mode.
When an emergency broadcast (ALARM signal) is sent from an FM station:
The receiver automatically tunes in the station except in the following cases:
•When you are listening to
•When the receiver is in standby mode.
While receiving an emergency broadcast, “ALARM” appears on the display.
The TEST signal is used for equipment test — whether it can receive the ALARM signal correctly.
The TEST signal makes the receiver work in the same way as the ALARM signal does. If the TEST signal is received, the receiver automatically switches to the station broadcasting the TEST signal. While receiving the test signal, “TEST” appears on the display.
Notes:
•EON data sent from some stations may not be compatible with this receiver.
•In EON standby mode, if you carry out synchronized recording (see page 28), EON standby mode is canceled temporarily. The receiver goes back to EON standby mode again when you have finished that operation.
•The EON mode only works when receiving an FM station with the EON code. (The EON indicator lights up while receiving an AM station but the EON function will not work.)
•While listening to a program tuned in by the EON function, you cannot use source selecting buttons and PTY SEARCH button.
CAUTION:
When the source alternates intermittently between the station tuned in by the EON function and the currently selected source, press EON to cancel the EON function.
If you do not press the button, the currently tuned station is received finally, and the indication of the EON program type flashing on the display disappears.
To stop listening to the program selected by EON
Press EON so that the program type (TA/NEWS/INFO) indicator goes off from the display. The receiver enters EON off mode and goes back to the previously selected source.
•Each time you press EON, the EON mode alternates between standby mode and off mode.
20