JVC RX-6010RBK, RX-6012RSL Operating JVC’s Audio/Video Components, Operating Audio Components

Page 32

Operating JVC’s Audio/Video Components

You can operate JVC’s audio and video components with this receiver’s remote control, since control signals for JVC components are preset in the remote control.

Operating Audio Components

IMPORTANT:

To operate JVC’s audio components using this remote control:

•You need to connect JVC audio components through the COMPU LINK (SYNCHRO) jacks (see page 28) in addition to the connections using cables with RCA pin plugs (see page 5).

•Aim the remote control directly at the remote sensor on the receiver.

•If you use the buttons on the front panel, the remote control will not operate that source. To operate a source with the remote control, the source must be selected using source selecting buttons on the remote control.

•To operate the cassette deck or CD recorder using the COMPU LINK remote control system, set the source name correctly. (See page 11.)

•Refer also to the manuals supplied with your components.

SLEEP TV VCR AUDIO

SURROUND

TEST

– SUBWOOFER +

 

1

2

3

SURROUND

 

5

 

MODE

EFFECT

– CENTER +

 

4

5

6

 

5

 

5

SOUND

– VCR CH + – REAR•L +

 

7/P

8

9

TV/VIDEO

CD-DISC

5

MENU

– REAR•R +

 

 

10

+10

DVD

 

 

ENTER

TV SOUND

VCR ANALOG/DIGITAL

CD

TAPE/CDR

 

FM/AM

 

 

 

MUTING

+

 

+

 

TV VOL

VOLUME

 

––8

£PTY SEARCH

+ 1

1

TV CH

–

PTY –

7 DISPLAY

+ PTY

RM - SRX6010R

REMOTE CONTROL

A/V CONTROL RECEIVER

￿

Tuner

After pressing FM/AM, you can perform the following operations:

FM/AM: Alternates between FM and AM (MW/LW).

1 – 10, +10: Selects a preset channel number directly. For channel number 5, press 5.

For channel number 15, press +10, then 5. For channel number 20, press +10, then 10.

PTY SEARCH: Searches for a program by PTY codes.

PTY +/–: Selects the PTY codes.

DISPLAY: Shows the RDS signals.

Sound control section (Amplifier)

You can always perform the following operations:

SURROUND:Turns on or off the Surround modes — Dolby Pro Logic, Dolby Digital, and DTS Digital Surround.

SURROUND MODE: Selects the DSP modes.

After pressing SOUND, you can perform the following operations:

SUBWOOFER +/–: Adjusts the subwoofer output level.

CENTER +/–:

Adjusts the center speaker output level.

REAR•L +/–:

Adjusts the left rear speaker output level.

REAR•R +/–:

Adjusts the right rear speaker output level.

EFFECT:

Selects the effect level.

TEST:

Turns on or off the test tone output.

Note:

After adjusting sounds, press the corresponding source selecting button or CD-DISC to operate your target source by using the 10 keys; otherwise, the 10 keys cannot be used for operating your target source.

CD player

After pressing CD, you can perform the following operations on the CD player:

3:

Starts playing.

4:

Returns to the beginning of the current

¢:

(or previous) track.

Skips to the beginning of the next track.

7:

Stops playing.

8:

Pauses playing. To release it, press 3.

1 – 10, +10:

Selects a track number directly.

 

For track number 5, press 5.

 

For track number 15, press +10, then 5.

For track number 20, press +10, then 10.

For track number 30, press +10, +10, then 10.

29

Page 31 Page 33
Image 32
Page 31 Page 33
Contents RX-6010RBK / RX-6012RSL If in Doubt Consult a Competent Electrician RX-6010RBK RX-6012RSL Table of Contents W e r t Remote Control Front PanelParts Identification Before Installation Checking the Supplied AccessoriesConnecting the FM and AM MW/LW Antennas Getting StartedConnecting the Speakers Basic connecting procedureConnecting the front speakers Connecting the rear and center speakersConnecting Audio/Video Components Connecting the subwoofer speakerAnalog connections Audio component connectionsVideo component connections DVD playerOutput To video inputConnecting the Power Cord Putting Batteries in the Remote ControlPlug the power cord into an AC outlet Digital connectionsTurning the Power On and Off Standby From the remote controlSignal and speaker indicators on the display Basic OperationsListening Only with Headphones Through all speakers and headphones ConnectedMuting the Sound Press Muting to mute the soundAttenuating the Input Signal Adjusting the Subwoofer Output LevelAdjusting the Tone Basic Settings Recording a Source Setting the Subwoofer InformationAdjusting the Front Speaker Output Balance Changing the Source NameSetting the Speakers for the DSP Modes To select the low frequency effect Attenuator level Crossover FRQ Crossover Frequency appears on the displayLFE ATT Low Frequency Effect Attenuator appears on Display Digital Input Digital in Terminal Setting Selecting the Analog or Digital Input ModeStoring the Basic Settings Adjustments Using the Sleep TimerChange the input mode Press Sleep repeatedlyReceiving Radio Broadcasts Tuning in Stations ManuallyUsing Preset Tuning Selecting the FM Reception Mode Using the RDS Radio Data System to Receive FM Stations Searching for a Program by PTY CodesSwitching to a Broadcast Program of Your Choice Temporarily Press EON so that the last selectedProgram type appears on the display Press TA/NEWS/INFO untilTo stop listening to the program selected by EON You have selectedIf the FM station you are listening to is Surround modes Using the DSP ModesWhat are the DSP Modes? Reproducing the Sound Field DAP modesEarly reflections Behind Direct sounds Possible × ImpossibleAvailable DSP Modes According to the Speaker Arrangement FrontAdjusting the Surround Modes Adjust the effect level JVC Theater Surround adjustmentsLevel you want Press Test again to stop the test toneAdjusting the DAP Modes Press DSP Mode repeatedly untilAdjust the rear speaker output levels Press Sound Adjust the rear speaker outputMode you want appears on Display Press Surround ModeActivating the DSP Modes Press Surround ON/OFFCompu Link Remote Control System Remote Control through the Remote Sensor on the ReceiverPress the play 3 button on the CD player Automatic Source SelectionOperating JVC’s Audio/Video Components Operating Audio ComponentsTuner Sound control section AmplifierOperating Video Components CD changerCassette deck CD recorderTroubleshooting Problem Possible Cause SolutionSpecifications AmplifierFM tuner IHF AM MW/LW tuner0301NHMMDWJEIN
Top Page Image Contents