Weider Pro 208 user manual Folding the Backrest, Adjusting the Weight Bench for Squat Exercises

FOLDING THE BACKREST

To perform squat exercises, the Backrest (23) must be folded to the upright position. To fold the Backrest, lift and pull it forward as far as it will go. It will be held in place by its own weight.

WARNING: Always fold the Backrest (23) out of the way when performing squat exercises. Do not sit on the seat when the Backrest is folded.

ADJUSTING THE WEIGHT BENCH FOR SQUAT

EXERCISES

To perform squat or toe raise exercises, fold the Backrest (23) to the upright position as described above.

Next, remove the Adjustment Tube (12).

Move the Weight Rests (11) to one of the highest posi- tions (see ADJUSTING THE WEIGHT RESTS earlier in

this section). Make sure that the Weight Rests have been turned around as shown.

WARNING: Always place 50 pounds on the leg lever to balance the bench when performing squat exercises.

WARNING: Always fold the Backrest (23) out of the way when performing squat exercises.

WARNING: Do not stand with your back to the weight bench when performing squat exercises. You should be able to see the weight rests while exercising so that you can safely return the bar- bell (not included) when you finish the exercise.

ADJUSTING THE LEG SUPPORT PADS

The Long Pad Tube (16) with Foam Pads (18) is mounted in the bracket (F) on the Front Leg (4). It can be placed in two different positions.

To move the Long Pad Tube (16), pull off one of the Foam Pads (18). Pull the Long Pad Tube out of the bracket. Insert the Long Pad Tube into the other hole and slide the Foam Pad back into place.

Note: The bracket (F) on the Front Leg (4) may have three adjustment holes on your particular weight bench.