Weider WESY19610 Nylon Locknuts yet, Tighten all of the 5/16 Nylon Locknuts 3 used in steps 1 to

FRAME ASSEMBLY

1.Before beginning assembly, make sure that you have read and understand the information on page 5.

Press a 2” Square Outer Cap (51) onto each end of the Stabilizer (5). Press a 2” Square Outer Cap

(51)onto the Base (4). Press a 2” Square Inner Cap (76) into the Rear Upright (56).

See the inset drawing. Press a 2” Square Inner Cap (76) into the other end of the Base (4). Insert two 5/16” x 2 1/2” Carriage Bolts (1) up into the Base.

Insert two additional 5/16” x 2 1/2” Carriage Bolts

(1)and a 3/8” x 3 1/2” Bolt (16) up into the Base

(4).Insert two 5/16” x 2 3/4” Carriage Bolts (94) up into the Stabilizer (5).

Place a piece of tape over the head of the seven bolts to hold them in place.

Slide the indicated end of the Base (4) onto the 5/16” x 2 3/4” Carriage Bolts (94) in the Stabilizer

(5). Slide the Rear Upright (56) onto the Carriage Bolts. Hand tighten two 5/16” Nylon Locknuts (3) onto the Carriage Bolts. Do not tighten the

Nylon Locknuts yet.

2.Slide the Front Upright (42) onto the 5/16” x

2 1/2” Carriage Bolts (1) in the Base (4). Hand tighten two 5/16” Nylon Locknuts (3) onto the Carriage Bolts. Do not tighten the Nylon

Locknuts yet.

3.Press a 2” Square Inner Cap (76) into the indicat- ed end of the Top Frame (55). Press three 1 3/4” Square Inner Caps (44) into the Top Frame.

Press two 1” Inner Caps (81) into the top of the crossbar on the Top Frame.

Attach the Top Frame (55) to the Front Upright (42) and the Rear Upright (56) with four 5/16” x

2 3/4” Bolts (11), the Long Support Plate (91), the Short Support Plate (103), and four 5/16” Nylon Locknuts (3) as shown.

Tighten all of the 5/16” Nylon Locknuts (3) used in steps 1 to 3.

6

1
		56
	3
		76
		51	51
5			4
51
	94
	16	1
4
1	76
2
		42
		3
			4
	1
3	11
91	11
		44
76	103
		81	44
55
44		Crossbar
3
56	3	42