Cable/Seat Assembly
12.Locate the parts bag labeled “CABLE ASSEMBLY
AND PULLEYS.” For cable identification and rout- ing during steps 12 through 27, refer to the Cable Diagram and Cable ID Chart on pages 15 and 16.
Slide a 3/8” Flat Washer (9) and a 1/2” x 1/4” Spacer
(44)onto a 3/8” x 2” Bolt (12). Next, hold a 3 1/2” Pulley (15) inside the slot in the Top Frame (55), and insert the Bolt through the Top Frame and the Pulley.
Slide another 1/2” x 1/4” Spacer (44) and another 3/8” Flat Washer (9) onto the Bolt and tighten a 3/8” Nylon Jamnut (22) onto the Bolt.
Locate the Short Cable (58). It is about 130” long and it has a ball on one end and a loop on the other end. Wrap the end with the ball around the
3 1/2” Pulley (15) in the direction shown.
Attach a 5/16” x 2” Bolt (78), a 1/2” x 1 3/8” Spacer (61), and a 5/16” Nylon Locknut (3) to the Top Frame
(55) in the indicated location. Make sure that the
Short Cable (58) is between the Pulley (15) and
the Spacer. Next, press a 1 1/2” Square Inner Cap
(32)into the indicated end of the Top Frame.
13.Remove the
Route the Short Cable (58) through the Large Pulley
Bracket (40) as shown.
Attach a 3 1/2” Pulley (15) inside the Large Pulley
Bracket (40) with a 3/8” x 1 3/4” Bolt (68) and a 3/8”
Nylon Jamnut (22). Make sure the Cable runs over the top of the Pulley.
Route the Short Cable (58) down through the hole in the Top Frame (55).
14.Remove the pre-attached Pulleys (15) from the “I”- Plates (20).
Wrap the Short Cable (58) around a 3 1/2” Pulley (15) in the direction shown. Attach the Pulley and a Cable
Trap (66) to the top hole in the
2” Bolt (12) and a 3/8” Nylon Locknut (21). | Note: |
Make sure the |
|
with two holes is pointed upward. Make sure the |
|
Cable Trap is oriented as shown. |
|
10
12 |
|
| 44 |
| 15 |
44 | 12 |
| 58 |
9 |
|
22 |
|
| 9 |
| 78 |
| 32 |
55 | 3 |
| |
| 61 |
13 | 68 |
| |
40 |
|
Hole | 15 |
| 55 |
22 |
|
58 |
|
14 |
|
58 | Two |
| |
66 | Holes |
| 21 |
15 |
|
12 |
|
20 |
|