Weider 740 user manual Cable Diagrams, Shooting and Maintenance on

Page 15

30.Press a 3/4” Round Inner Cap (34) into each end of the Pad Tube (28).

Insert the Pad Tube (28) through the indicated hole in the Leg Lever (29). Slide a Foam Pad (30) onto each end of the Pad Tube.

30

29

34

30

28

30

34

31. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in

ADJUSTMENT, beginning on page 17 of this manual.
Before using the weight system, pull each cable a few times to make sure that the cables move smoothly
over the pulleys. If one of the cables does not move smoothly, find and correct the problem.	IMPORTANT: If
the cables are not properly installed, they may be damaged when heavy weight is used. If there is
any slack in the cables, you will need to remove the slack by tightening the cables. See TROUBLE-
SHOOTING AND MAINTENANCE on page 18.

Cable Diagrams

The cable diagrams below and on the next page show the proper routing of the Short Cable (58), the Butterfly
Cable (76), and the Long Cable (23). The numbers show the correct route for each Cable.	Make sure that the
Cables are routed correctly, that the pulleys move smoothly, and that the cable traps do not touch or
bind the Cables. Incorrect cable routing can damage the weight system.

2	Short Cable (58)
4
	1
3
5
	15

Butterfly Cable (76)

4

2

5

1

3

Image 15

Contents Serial Number Decal Model No. WESY74091 Serial NoLimited Warranty Table of ContentsImportant Precautions Make sure the cables remain on the pulleysKeep hands and feet away from moving parts Before You Begin Using the weight systemAssembly To make the assembly process as smooth as possiTo complete the process over a couple of evenings Tighten the Nylon Locknuts yet Locate and open the parts bag labeled Frame AssemblySee the inset drawing Bolts with two 5/16 Nylon LocknutsFrame Place the Top Frame 55 on top of the UprightDo not tighten Nylon Locknuts3 yet SlotMake sure the welded tab on the Press Frame Top Frame Weight Guide TubeTop Frame Locate and open the parts bag labeled ARMTion of the welded bracket a on each Arm Cable Trap is oriented as shown Locate the parts bag labeled Cable AssemblyShort Cable 58 is between the Pulley 15 Bolt 12 and a 3/8 Nylon LocknutSpacer 8 x 1 Bolt 59, a 3/8 Plain Nut 56 and a 3/815b From Pulley To Pulley Bracket Onto the Bolt to prevent the Pulley from falling off durIng the following steps. Note Make sure the Pulley View from behindBolt 12 and a 3/8 Nylon Locknut 21. Note Make sure the Cable Trap is oriented as shownSpacer To the Seat 13 with two 1/4 x 3/4 Screws Shooting and Maintenance on Cable DiagramsLong Cable 76, 87 1/258, 126 1/4 Attaching the Lat Bar to the Pulley Station AdjustmentCise will be reduced Changing the Weight Setting Adjusting the Arms for Butterfly or Press ExercisesCable and re-install it Trouble-shooting and MaintenanceWeight Resistance Chart Station LeverTop Part No R0101A Ordering Replacement PartsWESY74091 R0101A Remove this Part Identification Chart from the ManualPart Identification Chart-WESY74091 Page Page Remove this Part LIST/EXPLODED Drawing from the Manual Part List-Model No. WESY74091 Qty Description16 x 2 1/4 Bolt Backrest Nylon Locknut Exploded Drawing-Model No. WESY74091 R0101A